Scribd
Upload
10 views

Appendix B Thesis

This document contains 16 figures documenting tests performed on crumbed rubber concrete wall panels. The figures show steps of the testing process such as sieving crumbed rubber, mixing concrete with rubber, molding test specimens, and conducting compression, flexural, fire resistance, sound insulation and other tests. The fire resistance test involved exposing a wall panel to fire for 240 minutes and documenting the effects of heat exposure over time through temperature readings and observations of cracking and deterioration.

Uploaded by

Maiko Laine Carbonel
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
10 views

Appendix B Thesis

This document contains 16 figures documenting tests performed on crumbed rubber concrete wall panels. The figures show steps of the testing process such as sieving crumbed rubber, mixing concrete with rubber, molding test specimens, and conducting compression, flexural, fire resistance, sound insulation and other tests. The fire resistance test involved exposing a wall panel to fire for 240 minutes and documenting the effects of heat exposure over time through temperature readings and observations of cracking and deterioration.

Uploaded by

Maiko Laine Carbonel
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 12

95

APPENDIX B
DOCUMENTATIONS

Figure B.1 Sieving Crumbed Rubber

Figure B.2 Rubber Treatment Using 10% Concentration of Sodium Hydroxide (NaOH)

96

Figure B.3 Specific Gravity of Sand

Figure B.4 Unit Weight of Crumbed Rubber

97

Figure B.5 Specific Gravity of Cement

Figure B.6 Mixing Controlled and with 10% Crumbed Rubber

98

Figure B.7 Molding Specimens

Figure B.8 Compressive Testing of Specimens

99

Figure B.9 Flexural Testing of Specimens

Figure B.10 Fabrication of Wall Panel

100

Figure B.11 Filling of Mortar Mix to Wall Panel

Figure B.12 Setting-Up Flexural Testing for Wall Panel

101

Figure B.13 Flexural Testing for Wall Panel

102

103

Figure B.14 Sound Insulation Testing

104

Figure B-15.1 Temperature Gun

Figure B-15.2 Setup for Fire Resistance Test

Figure B-15.3 Start of Fire test

Figure B-15.4 Wall Panel underwent discoloration


after thirty (30) minutes

Figure B-15.5 Microcrackings started to develop on


the exposed surface after forty (40) minutes.

Figure B-15.6 Microcrackings continued to propagate


on the exposed surface after fifty (50) minutes.

Figure B.15 Fire Rating Test

105

Figure B-15.7 Temperature reading on the exposed


side of the wall panel

Figure B-15.9 Fibrocement board started to crack


after seventy (70) minutes.

Figure B-15.8 Temperature reading on the unexposed


side of the wall panel

Figure B-15.10 Mortar filler was exposed to fire due


to the deterioration of fibrocement board after eighty
(80) minutes.

Figure B.15 Fire Rating Test

106

Figure B-15.11 Crackings on the exposed side grew


largely after 100 minutes.

Figure B-15.12 Temperature on the unexposed side


reached the limit for fire test after 120 minutes.

Figure B-15.13 Exposed side of the wall continued to


burn after 150 minutes

Figure B-15.14 Fibrocement board on the exposed


side wore out after 180 minutes

Figure B-15.15 Exposed


sideB-15.16
of the wall
sufferedWall Panel after fire test
Figure
Composite
excessive darkening due
to heat
after 210 minutes.
of 240
minutes.

Figure B.15 Fire Rating Test

You might also like