Scribd
Upload
4K views

Arduino Based Underground Cable Fault Detection

This project uses an Arduino board to detect the location of faults in underground electrical cables. It works by applying a low DC voltage through a series resistor to the cable lines. When a fault occurs, the current varies depending on the location. The Arduino board interfaces with a current sensing circuit and LCD display to show the fault location in kilometers. It detects faults by measuring changes in voltage across resistors when a short circuit occurs between the line and ground. The system could be improved to also locate open circuits by using capacitors to measure cable impedance.

Uploaded by

ashish
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
4K views

Arduino Based Underground Cable Fault Detection

This project uses an Arduino board to detect the location of faults in underground electrical cables. It works by applying a low DC voltage through a series resistor to the cable lines. When a fault occurs, the current varies depending on the location. The Arduino board interfaces with a current sensing circuit and LCD display to show the fault location in kilometers. It detects faults by measuring changes in voltage across resistors when a short circuit occurs between the line and ground. The system could be improved to also locate open circuits by using capacitors to measure cable impedance.

Uploaded by

ashish
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Arduino based Underground Cable Fault Detection

ABSTRACT
The project is intended to detect the location of fault in underground cable lines from the base
station in kilometers using an Arduino board.This project uses the standard concept of Ohms law
i.e., when a low DC voltage is applied at the feeder end through a series resistor to the Cable
lines, then current would vary depending upon the location of fault in the short circuited cable.
In the urban areas, the electrical cables runs in undergrounds instead of overhead lines.
Whenever the fault occurs in underground cable it is difficult to detect the exact location of the
fault for process of repairing that particular cable. The proposed system finds the exact location
of the fault.
This system uses an Arduino board and a rectified power supply. Here the current sensing circuit
made with combination of resistors are interfaced to Arduino board with help of the internal
ADC device for providing digital data to the microcontroller representing the cable length in
KMs. The fault creation is made by the set of switches. The relays are controlled by the relay
driver IC which is used for switching the power sequentially to all the lines . A 16x2 LCD
display connected to the microcontroller to display the information.
In case of short circuit (Line to Ground), the voltage across series resistors changes accordingly,
which is then fed to an ADC to develop precise digital data to a programmed Arduino board that
further displays fault location in kilometers.
The project future can be implemented by using capacitor in an ac circuit to measure the
impedance which can even locate the open circuited cable.

BLOCL DIAGRAM:

HARDWARE REQUIREMENTS:

SOFTWARE REQUIREMENTS:

LCD, Crystal,
Relays, Relay Driver IC,
Transformer, Diodes, Voltage Regulator, Resistors,

Language: Arduino Programming Language.

Capacitors, LEDs, slide switches, Arduino

board

You might also like