Scribd
Upload
93 views

Laboratory Sample Report

This laboratory report describes an experiment on clipper circuits performed by students Affan Bhoira, Abdullah Raid Yaseen, and Firas Nedal Hammad. The report provides background information on clipping circuits and half-wave rectifiers. It documents the students building three clipper circuits on breadboards with a 4 Vp-p sinusoidal wave signal at 2 kHz as input. Simulation results of the clipper circuit in MultiSim are also included with a diagram of the circuit.

Uploaded by

affan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
93 views

Laboratory Sample Report

This laboratory report describes an experiment on clipper circuits performed by students Affan Bhoira, Abdullah Raid Yaseen, and Firas Nedal Hammad. The report provides background information on clipping circuits and half-wave rectifiers. It documents the students building three clipper circuits on breadboards with a 4 Vp-p sinusoidal wave signal at 2 kHz as input. Simulation results of the clipper circuit in MultiSim are also included with a diagram of the circuit.

Uploaded by

affan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

Ajman University of Science & Technology

College of Engineering
Department of Electrical Engineering

2112510: Electronic Devices & Circuits I


Laboratory Report
Experiment (3): Clippers
Name: Affan Bhoira
ID: 201410646
Group Names:
Name: Abdullah Raid Yaseen
201211927
Name: Firas Nedal Hammad
201411274

ID:
ID:

Laboratory Section (Day/Time): Monday, 8:00 AM


Instructor: Engr. Wessam Ghassan Shehieb
Comments & Marks:
__________________________________________________________________
__________________________________________________________________

__________________________________________________________________
____________________________________________________________

Description
1. The circuit with which wave form is shaped by removing a
portion of the applied wave is known as clipping circuit.
Clipping circuits (also known as limiters, amplitude selectors,
or slicers), are used to remove the part of a signal that is
above or below some defined reference level.
2. An example of a clipper circuit is the half-wave rectifier. The
half-wave rectifier is a circuit that allows only part of an input
signal to pass. The circuit is simply the combination of a
single diode in series with a resistor, where the resistor is
acting as a load.

Practical Results:

Circuit on breadboard

Circuit on breadboard2

Circuit on breadboard 3

Wave Signal Of 4 Vp-p

Frequency Of 2K
Simulation
We will simulate the project on MultiSim,

10k

U1

D1

0.369

2Vpk
20kHz
0

R1

V1

You might also like