Scribd
Upload
1K views

Astm d7234

This standard test method describes procedures for evaluating the pull-off adhesion strength of coatings on concrete using portable pull-off adhesion testers. It determines the greatest perpendicular force that can be applied before the coated surface detaches. The test exposes the weakest plane of adhesion between the testing fixtures, coating layers, adhesive, and substrate. Pull-off strength depends on both the materials and testing instrument used, so the specific instrument must be reported with any results. This destructive test may require spot repairs after testing.

Uploaded by

Juan Manuel Rodriguez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
1K views

Astm d7234

This standard test method describes procedures for evaluating the pull-off adhesion strength of coatings on concrete using portable pull-off adhesion testers. It determines the greatest perpendicular force that can be applied before the coated surface detaches. The test exposes the weakest plane of adhesion between the testing fixtures, coating layers, adhesive, and substrate. Pull-off strength depends on both the materials and testing instrument used, so the specific instrument must be reported with any results. This destructive test may require spot repairs after testing.

Uploaded by

Juan Manuel Rodriguez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

ASTM D7234-12

Standard Test Method for Pull-Off Adhesion Strength of Coatings on Concrete Using
Portable Pull-Off Adhesion Testers

1.1 This test method covers procedures for evaluating the pull-off adhesion strength of a
coating on concrete. The test determines the greatest perpendicular force (in tension)
that a surface area can bear before a plug of material is detached. Failure will occur
along the weakest plane within the system comprised of the test fixture, adhesive,
coating system, and substrate, and will be exposed by the fracture surface.
1.2 This test method uses a class of apparatus known as portable pull-off adhesion
testers. 2 They are capable of applying a concentric load and counter load to a single
surface so that coatings can be tested even though only one side is accessible.
Measurements are limited by the strength of adhesion bonds between the loading fixture,
coating system and the substrate or the cohesive strengths of the adhesive, coating
layers, and substrate.
1.3 Pull-off adhesion strength measurements depend upon both material and instrumental
parameters. There are different instruments used that comply with this test method. The
specific instrument used should be identified when reporting results. This test is
destructive and spot repairs may be necessary.
1.4 The values stated in SI units are to be regarded as the standard. The values given in
parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any,
associated with its use. It is the responsibility of the user of this standard to establish
appropriate safety and health practices and determine the applicability of regulatory
limitations prior to use.

You might also like