Scribd
Upload
893 views

Power and Control Cable Installation ITP

This inspection and test plan outlines the steps for installing power and control cables at the Khelvachuri Hepp project. It lists 14 points of inspection including verifying the cable route is ready, the correct cable type and size are installed without damage, cable glanding and terminations are complete, insulation resistance and continuity checks are passed after connections are made, and the full cable installation is complete and meets requirements. The plan specifies checking manufacturer's instructions and specifications at various steps to ensure proper installation of the cables.

Uploaded by

kamil
Copyright
© © All Rights Reserved
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
893 views

Power and Control Cable Installation ITP

This inspection and test plan outlines the steps for installing power and control cables at the Khelvachuri Hepp project. It lists 14 points of inspection including verifying the cable route is ready, the correct cable type and size are installed without damage, cable glanding and terminations are complete, insulation resistance and continuity checks are passed after connections are made, and the full cable installation is complete and meets requirements. The plan specifies checking manufacturer's instructions and specifications at various steps to ensure proper installation of the cables.

Uploaded by

kamil
Copyright
© © All Rights Reserved
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 1

INSPECTION AND TEST PLAN FOR POWER AND CONTROL CABLE INSTALLATION

Project Name: Khelvachuri Hepp

Dok. No:

FR.752.38

Yay.Tar.

1/25/2013

Rev. No.

Rev. Tarihi
Point

ctivity

Relevant Document

Inspection / Test Requirements

KESIR
ENGINEERING

CUSTOMER

--

CONTRACTOR

Notes

POWER AND CONTROL CABLE INSTALLATION


* By checking completion of trays enough for cable pulling

Cable route ready for cable installation

Correct cable type and size which is free from damage


installed, as per requirement.

* Verify no undue mechanical stress is applied to cable during installation. *


Verify cable manufacturer's criteria for max. Tension on cables during pulling,
no kinking.
*
Verify correct segregation/layering of cables.
*
Verify correct cable ID.
* Verify correct splicing as per spec.
* Verify min. bending radius of cable as per cable manufacturer

Manufacturer's
instructions

Cable glanding/termination complete

* Verify terminating materials are of specified


type.
.* Verify cable connection tight and secure.

Manufacturer's
instructions

Insulation resistance test and continuity check after


glanding/lugging complete.

* Verify continuity and insulation resistance test complete and conformant.

Manufacturer's
instructions

Cable installation complete

* Verify all inspection and tests complete and conformant.

8
9

10

11
12
13
14
otes

Abbreviations
E : Works Execution

R
Revision
0

: Records review

Modifications

: Witness point
: Hold point

Prepared by

sw : Spot Witness point


A : Approval

Approved by

Date

1/1

You might also like