Scribd
Upload
675 views

Ut Format Aws

This 3-page ultrasonic testing report summarizes an inspection of welds on an unspecified structure. It provides details of the inspection such as the date, test procedures used, acceptance criteria, equipment used including probes, and qualifications of those performing the inspection. The second page begins listing inspection results for each weld or item tested, noting any defects found along with their length, depth, amplitude, and location.

Uploaded by

manjeev111
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
675 views

Ut Format Aws

This 3-page ultrasonic testing report summarizes an inspection of welds on an unspecified structure. It provides details of the inspection such as the date, test procedures used, acceptance criteria, equipment used including probes, and qualifications of those performing the inspection. The second page begins listing inspection results for each weld or item tested, noting any defects found along with their length, depth, amplitude, and location.

Uploaded by

manjeev111
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Form A

ULTRASONIC TESTING REPORT


Page 1 of 3
Reference No.
Report No.
Client

Date:
Inspection Date:

Consultant
Contractor

Project
Subject
Material
Weld Type
Weld Process
Surface Condition
Test Procedure
Acceptance Criteria

AWS D.1.1 Table S.1: 2010

Couplant

Wall Paper Paste

Calibration Block

V1,V2 S/No.

AWS DAC Block

Test Equipment
Model

Serial No.

Amplitude Linearity

10%

Horizontal Linearity

2%

Resolution

Good

Range:

mm

Probe & Cable Details


Cable Type & Length

Lemo ; 2 meter

Sensitivity Setting

P.R.E. Set at 80% Full Screen Height

Transfer Loss
Brand

Size

Frequency

True Angle

S/No.

Crystal Type

10 mm

5 MHz

Twin

8x9 mm

4 MHz

70

Sinlge

8x9 mm

4 MHz

60

Sinlge

8x9 mm

4 MHz

45

Sinlge

Index Point

Sensitivity

NDT Inspector
Qualification

Tested By

Reviewed By

Client's Authorized
Representative

Client's
Representative

Page 2 of 3
Date:

Reference No.
Report No.

Drawing:

#Remarks: Please refer to the attached skecth/photo; Welder Identification comply to particular Weld No./Location(if any)
* Lenged: ACC - Accpeted, REJ - Rejected, NAD - No Apparent Defect

# Remarks

* Result

Defect Length (mm)

Defect Depth (mm)

Amplitude (% of SSL)

Location from (mm)

Indication No.

Probe Angle ()

Test Length (mm)

Thk / Pipe Sch. (mm)

Diameter (mm)

Weld No./Location

Item/Drawing No.

S/No.

INDICATION REPORT AND RESULT

You might also like