Scribd
Upload
127 views1 page

SGT - Le.017 Sheave Block &amp Snatch Block

SGT Engineering provides inspection criteria for sheave blocks and snatch blocks. Any sheaves with wear exceeding gauge depth, or severe nicks, cuts or corrosion are cause for rejection. Sprockets or cheek plates with cracks, heat damage, severe impacts or excessive corrosion also require rejection. Pins with over 10% wear or attachment points with over 5% wear or signs of cracks, cuts or corrosion fail inspection.

Uploaded by

ryangillespie
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
127 views1 page

SGT - Le.017 Sheave Block &amp Snatch Block

SGT Engineering provides inspection criteria for sheave blocks and snatch blocks. Any sheaves with wear exceeding gauge depth, or severe nicks, cuts or corrosion are cause for rejection. Sprockets or cheek plates with cracks, heat damage, severe impacts or excessive corrosion also require rejection. Pins with over 10% wear or attachment points with over 5% wear or signs of cracks, cuts or corrosion fail inspection.

Uploaded by

ryangillespie
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Doc Ref: SGT.LE.

017

S.G.T Engineering Ltd.


NDT/Lifting Equipment Inspection

Inspection criteria - Sheave Block and Snatch Block

The Lifting Engineer shall conduct a thorough inspection of the block in its assembled
condition. Any of the following defects found during inspection shall be cause for rejection:

COMPONENT DEFECT TYPE REJECTION CRITERIA


Sheaves (where a) Wear a) Wear of rope groove in excess of gauge depth.
fitted) b) Damage b) Severe nicks, cuts or gouges.
c) Corrosion c) Excessive corrosion, pitting or chemical attack
on steel sheaves.
Sprockets a) Wear a) Excessive wear of chain guide.
(where fitted) b) Damage b) Cracks, heat damage, severe nicks or gouges.
c) Corrosion c) Excessive corrosion, pitting or any chemical
attack.
Cheek Plates a) Damage a) Cracks, severe cuts, gouges or distortion.
b) Corrosion b) Excessive corrosion, pitting or any chemical
attack.
Pins a) Wear a) Any wear in excess of 10% of original diameter.
Attachment Point a) Wear a) Any wear in excess of 5% of original
b) Damage dimensions.
c) Corrosion b) Any cracks, cuts or distortion.
c) Excessive corrosion, pitting or chemical attack.

296 Union Grove, Aberdeen T: 01224 326503


AB10 6TP E: [email protected]
Company Registration No: 344980 E: [email protected]

You might also like