www.ccna4u.info www.ccna4u.

org
Thank CHRIS
Assessment System
Skip to Time Left | Skip to Navigation | Skip to Assessment Items

Take Assessment - EWAN Chapter 8 - CCNA Exploration: Accessing the WAN

(Version 4.0)
00:46:11
Time Remaining:

Showing 1 of 2 Next> 1 <Prev

Page: GO
1 Which troubleshooting approach is suggested for dealing with a complex problem that is suspect
being caused by faulty network cabling?
bottom up
top down
divide and conquer
middle out

2 A technician has been asked to troubleshoot an existing switched network but is unable to locate
documentation for the VLAN configuration. Which troubleshooting tool allows the technician to m
and discover VLAN and port assignments?
cable analyzer
network analyzer
protocol analyzer
knowledge base

3 Which two statements are true concerning logical networking models? (Choose two.)
TCP/IP splits the lowest layer of the OSI model into two separate layers.
The top layer of the TCP/IP model combines the functions of the top three OSI layers.
Troubleshooting with the TCP/IP model requires different techniques than with the OSI mode
The network access layer is responsible for exchanging packets between devices on a TCP/
network.
The Internet layer provides communication between applications, such as FTP, HTTP, and S
on separate hosts.
The TCP/IP network access layer corresponds to the OSI physical and data link layers.

4 Which two components should be taken into consideration when establishing a network baseline
(Choose two.)
information about the network design
 www.ccna4u.info www.ccna4u.org
Thank CHRIS
IP addressing allocation on the network
requirements about the service provider setup
requirements for access control lists to regulate traffic
expected performance under normal operating conditions

5 Information about which OSI layers of connected Cisco devices can be verified with the show cd
neighbors command?
All layers
Layer 1, Layer 2, and Layer 3
Layer 1, Layer 2, Layer 3, and Layer 4
Layer 6 and Layer 7

6 What is one example of a physical layer problem?

incorrect encapsulation
incorrect STP configuration
incorrect ARP mapping
incorrect clock rate

Refer to the exhibit. Users on the Internal LAN are unable to connect to the www server. The net
administrator pings the server and verifies that NAT is functioning correctly. Which OSI layer sho
the administrator begin to troubleshoot next?
physical
data link
network
application

8 Which two pieces of information are typically found on a logical network diagram? (Choose two.)
cable types
connector types
interface identifiers
DLCI for virtual circuits
 www.ccna4u.info www.ccna4u.org
Thank CHRIS
operating system versions

9 When gathering symptoms for troubleshooting a network problem, which step could result in gett
an external administrator involved in the process?
narrowing the scope
gathering symptoms from suspect devices
analyzing existing symptoms
determining ownership

10 Excessive broadcasts are generally a symptom of a problem at which layer?

physical
data link
network
transport

11 Clients across the company are reporting poor performance across all corporate applications run
in the data center. Internet access and applications running across the corporate WAN are perfo
normally. The network administrator observes a continual broadcast of random meaningless traff
(jabber) on the application server LAN in the data center on a protocol analyzer. How should the
administrator start troubleshooting?
The jabber in the data center indicates a local physical layer problem. Use the protocol analy
determine the source of the jabber, and then check for a recent NIC driver update or bad cab
Because all clients are experiencing application problems, the administrator should use a top
down approach with the application servers in the data center.
The scope of the problem indicates a likely routing or spanning-tree problem. Begin by check
routing tables, and follow up using appropriate STP show commands to find a loop if routing
working normally.
Poll the staff to determine if any recent changes have been made. Back out all the changes o
one until the error condition is fixed.

12 A technician has been asked to make several changes to the configuration and topology of a net
and then determine the outcome of the changes. What tool can be used to determine the overall
caused by the changes?
baselining tool
knowledge base
protocol analyzer
cable tester

13 Encapsulation errors from mismatched WAN protocols on a serial link between two routers indica
problem at which OSI layer?
physical
data link
 www.ccna4u.info www.ccna4u.org
Thank CHRIS
network
transport

14 What combination of IP address and wildcard mask should be used to specify only the last 8
addresses in the subnet 192.168.3.32/28?
192.168.3.32 0.0.0.7
192.168.3.32 0.0.0.15
192.168.3.40 0.0.0.7
192.168.3.40 0.0.0.15

15 Users are complaining of very long wait times to access resources on the network. The show
interface command reveals collision counts far above the network baseline. At which OSI layer s
the administrator begin troubleshooting?
application
transport
network
data link
physical

Showing 1 of 2 Next> 1 <Prev

Page: GO

All contents copyright 1992-2009 Cisco Systems, Inc. Privacy Statement and Trademarks

Assessment System
Skip to Time Left | Skip to Navigation | Skip to Assessment Items

Take Assessment - EWAN Chapter 8 - CCNA Exploration:

Accessing the WAN (Version 4.0)
00:45:07
Time Remaining:

Showing 2 of 2 Next> 2 <Prev

Page: GO
 www.ccna4u.info www.ccna4u.org
Thank CHRIS
16

Refer to the exhibit. Which three pieces of information can be determined by analyzing the outpu
shown? (Choose three.)
A carrier detect signal is present.
Keepalives are being received successfully.
Default encapsulation is used on this serial link.
Packets passing this interface cannot exceed 1 KB in size.
The reliability of this link is very low.
The LCP negotiation phase is complete.

17

Refer to the exhibit. Users at Branch B are reporting trouble accessing a corporate website runnin
a server that is located at HQ. HQ and Branch A users can access the website. R3 is able to ping
10.10.10.1 successfully but not 10.10.10.2. The users at Branch B can access servers at Branch
Which two statements are true aboutthe troubleshooting efforts? (Choose two.)
The web server should be tested for an application layer problem.
Frame Relay at R3 and R2 should be tested to narrow the scope of the problem.
 www.ccna4u.info www.ccna4u.org
Thank CHRIS
The fact that users at Branch A are working normally proves that there is no problem at R2.
An ACL entry error could cause the failure at Layer 4 in either R3 or R2.
The successful ping from R3 to R1 proves that the WAN is functioning normally. Therefore, th
problem has to be in the upper layers.

18 A network administrator has received complaints that users on a local LAN can retrieve e-mail fro
remote e-mail server but are unable to open web pages on the same server. Services at which tw
layers of the OSI model should be investigated during the troubleshooting process? (Choose two
physical layer
data link layer
network layer
transport layer
application layer

19

Refer to the exhibit. Which two steps should be taken during the process of creating network
documentation? (Choose two.)
Record the information about the devices discovered in the Campus network only.
Record the information about the devices discovered in the entire network, including the remo
locations.
Transfer any information about the devices from the network configuration table that correspo
to a component of the topology diagram.
Transfer only the Layer 2 and Layer 3 information about the devices from the network
 www.ccna4u.info www.ccna4u.org
Thank CHRIS
configuration table that corresponds to a component of the topology diagram.
Transfer the recorded information about the devices from the network configuration table gath
during peak network utilization that corresponds to a component of the topology diagram.

20 Which three approaches should be used when attempting to gather data from users for
troubleshooting? (Choose three.)
Determine fault.
Get to know the user to build trust.
Obtain information by asking simple pertinent questions.
Impress the user with use of technical language and skills.
Determine if the problem is related to time or a specific event.
Determine if the user can re-create the problem or events leading to the problem.

Showing 2 of 2 Next> 2 <Prev

Page: GO

All contents copyright 1992-2009 Cisco Systems, Inc. Privacy Statement

and Trademarks