Scribd
Upload
934 views

Icom IC-T8 Service Manual

Uploaded by

Yayok S. Anggoro
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
934 views

Icom IC-T8 Service Manual

Uploaded by

Yayok S. Anggoro
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 52
O ICOM SERVICE MANUAL FM TRANSCEIVER IC-T8A IC-T8E Icom Inc. INTRODUCTION This service manual describes the latest service information for ‘the IC-T8A/E FM TRANSCEIVER at the time of publication, VERSION USA SYMBOL UK. Italy ITA Thailand THA Taiwan TPE To upgrade quality, alll electrical or mechanical parts and inter- nal circuits are subject to change without netice or obligation. DANGER NEVER connect the transceiver to an AC outlet or toa DC power supply that uses more than 16 V. Such a connection could cause a fire hazard and/or electric shock. DO NOT expose the transceiver to rain, snow or any liq- vids. DO NOT reverse the polarities of the power supply when connecting the transcaiver. DO NOT apply an AF signal of more than 20 dBm (100 mW) to the antenna connector, This could damage the transceiver's front end. ORDERING PARTS Be sure to include the following four points when ordering replacement parts: 1. 10-digit order numbers 2, Component part number and name 3. Equipment model name and unit name 4, Quantity required 1110008490 SIC TASTIS6FN = IC-TaWE RFUNIT 1 piece 4810008990 Screw BO 2x10ZK IC-T&WE CHASSIS 6 piaces Addresses are provided on the inside back cover for your convenience. REPAIR NOTES Make sure a problem is intemal before disassembling the transceiver, DO NOT open the transceiver until the transceiver is disconnected from its power source. DO NOT force any of the variable components. Turn them slowly and smoothly. DO NOT short any circuits or electronic parts. An insulated tuning tool MUST be Used for all adjustments. DO NOT keap power ON for a long time when the transceiver is defective. DO NOT transmit power into a signal generator or a sweep generator. ALWAYS connect a 40 dB or 50 dB attenuator between the transceiver and @ deviation meter or spectrum analyser when using such test equipment. READ the instructions of test equipment thoroughly before connecting equipment to # NOR Eons 2 transcaiver. SECTION SECTION SECTION SECTION SECTION SECTION SECTION SECTION SECTION SECTION SECTION TABLE OF CONTENTS ‘SPECIFICATIONS INSIDE VIEWS DISASSEMBLY INSTRUCTIONS CIRCUIT DESCRIPTION RECEIVER CIRCUITS ... TRANSMITTER CIRCUITS. PLLCIRCUIT sn POWER SUPPLY CIRCUITS .. CPU PORT ALLOCATIONS .... ADJUSTMENT PROCEDURES PREPARATION... PLL ADJUSTMENT oes ‘TRIMMER ADJUSTMENT RECEIVER ADJUSTMENT... rooconenenes PARTS LIST MECHANICAL PARTS AND DISASSEMBLY ‘SEMI-CONDUCTOR INFORMATION BOARD LAYOUTS LOGIC UNIT.... BR UNIT oo cnsnnnninnnnnnnnnnnn 9-3 VCO BOARD nn o-1 9-38 BLOCK DIAGRAM VOLTAGE DIAGRAM

You might also like