How to build a

Radionics Device

That works by
Mind Power
 First layer made of copperfoil Connectors; use two to connect
to the dials, two to connect
to an antenna (or witness coil),
second layer: mirror two to connect to the rubbing plate
(try to get the best quality) and two to connect to the headband.

Third layer made of Orgonite

Magnets; 4 magnets with North up

and 4 magnets with North down

Place a CLEAN DTcrystal on the

third (orgon) layer, use tape to
connect, but NEVER use glue!!

Radionic Heart
this is the heart of the device,
see next page to find more instructions
© Kees de Jonge
 3
made of orgonite
1 cm thick .
2 3rd layer.
this is a
mirror.
2nd layer

1
this shape is made of
copperfoil.
1st layer

view from above

N

S S

4 5
N eight magnets N double terminated
connect to the copperfoil quartz crystal
N=North
S=South
side view
S S

© Kees de Jonge
 if you use more then 3

to the heart

to the heart

to witness coil
or Antena

How to connect the dials

to the heart

if you use 3 dials

(don’t use less!!)

The dials are potentiometers:

10KW, Wattage 1/2W,. Tolerance 20%, to the heart
6mm shaft.for knob, Mount in a 5/16"-diameter hole. to witness coil
or Antena

© Kees de Jonge
 Use this shape or this one or this one

connect to headband and rubbingplate

Witness coil

© Kees de Jonge
 Connect to the antenna or
Copperfoil witness coil

Connect to the heart Connect to the heart

Plastic layer, to be placed

OVER the copperfoil

Rubbing plate
( I use this triangle shape, but you can use any shape you want)

© Kees de Jonge
 Connect to the antenna or
witness coil
Connect to the heart
of the Device

Make a hole,
so the pyrite
Copperfoil Pyrite can be in touch Leather, or other skinfriendly material
with the skin of
your forehead
or your 3rd eye

Headband
use skinfriendly material like leather
© Kees de Jonge
 b

a
or use an
antenna
instead of
the coil

© Kees de Jonge