Scribd
Upload
40 views

DI96

This document provides instructions for troubleshooting a cruise control system without ETCS-i. It outlines a 10 step process: 1) analyze the customer's problem, 2) check and clear diagnostic trouble codes (DTCs), 3) confirm the symptom, 4) simulate the symptom if needed, 5) check for DTCs, 6) reference the DTC chart, 7) check for problem symptoms, 8) inspect circuits and input signals, 9) identify the problem, 10) perform a confirmation test or road test and clear DTCs if everything checks out. It directs the technician to specific pages in the manual for more details at each step.

Uploaded by

Erln Lima
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
40 views

DI96

This document provides instructions for troubleshooting a cruise control system without ETCS-i. It outlines a 10 step process: 1) analyze the customer's problem, 2) check and clear diagnostic trouble codes (DTCs), 3) confirm the symptom, 4) simulate the symptom if needed, 5) check for DTCs, 6) reference the DTC chart, 7) check for problem symptoms, 8) inspect circuits and input signals, 9) identify the problem, 10) perform a confirmation test or road test and clear DTCs if everything checks out. It directs the technician to specific pages in the manual for more details at each step.

Uploaded by

Erln Lima
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DI–719

DIAGNOSTICS – CRUISE CONTROL SYSTEM (w/o ETCS–i)

CRUISE CONTROL SYSTEM (w/o ETCS–i)


DI8Z7–02

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting in accordance with the procedure on the following pages.

Vehicle Brought to Workshop


Items inside are titles of pages in this
manual with the page number indicated in the
1 Customer Problem Analysis bottom portion. See the indicated pages
P. DI–720 for detailed explanations.

2 Check and Clear DTC (Pre–check)

P. DI–721

Symptom does not occur 4


3 Symptom Simulation
Problem Symptom Confirmation
P. IN–18

5 Normal code
DTC Check
P. DI–721
Malfunction code

6 7
DTC Chart Problem Symptoms Table
P. DI–726 P. DI–730

9
8 Input Signal Check
Circuit Inspection
Parts Inspection
P. DI–733 – DI–751

Identification of Problem

Repair Step 2, 5, 8, 10: Diagnostic steps permitting the use of


the TOYOTA hand–held tester.

NG
10
Confirmation Test or Road Test* *: See next page
OK

Clear DTC
End
P. DI–721

2003 TOYOTA TACOMA (RM1002U)

Author: Date: 981

You might also like