Scribd
Upload
2K views

Fanuc 0 Communications Parameters

This document provides information on communication parameters and procedures for punching, reading, and clearing data on FANUC 0T and 0M CNCs. It lists the TVON, ISO, I/O, and PWE parameters that control communications and provides the bit settings for port 1 and port 2 on parameters 0002, 0050, 0038, and 0552. Punching, reading, and clearing procedures are described for parameters, programs, and tool offsets using EDIT mode screens on the CNC.

Uploaded by

88No1Fan
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views

Fanuc 0 Communications Parameters

This document provides information on communication parameters and procedures for punching, reading, and clearing data on FANUC 0T and 0M CNCs. It lists the TVON, ISO, I/O, and PWE parameters that control communications and provides the bit settings for port 1 and port 2 on parameters 0002, 0050, 0038, and 0552. Punching, reading, and clearing procedures are described for parameters, programs, and tool offsets using EDIT mode screens on the CNC.

Uploaded by

88No1Fan
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

www.cncszerviz.

com

FANUC 0T & FANUC 0M COMMUNICATIONS PARAMETERS

TVON = 0
ISO = 1
I/O = 0 (if using port 1), I/O = 2 (if using port 2)
PWE = 1
TAPEF = 0

CNC Port 1 Port 2


Parameter (M5) (M74)
0002 1xxxxxx1 --
0050 -- 1xxxxxx1
0038 01xxxxxx xx01xxxx
0552 10 --
0253 -- 10

Punching Procedure
Punch NC Parameters - EDIT mode, PARAM screen, EOB + OUTPUT/START
Punch PC Parameters - EDIT mode, DGNOS screen, OUTPUT/START
Punch All Programs - EDIT mode, PRGRM screen, 0-9999, OUTPUT/START
Tool Offsets - EDIT mode, OFFSET screen, OUTPUT/START

Reading Procedure
Load NC Parameters - EDIT mode, PARAM screen, EOB + INPUT
Load PC Parameters - EDIT mode, DGNOS screen, INPUT
Load All Programs - EDIT mode, PRGRM screen, INPUT
Load Tool Offsets - EDIT mode, OFSET screen, INPUT

Clearing Procedure
Delete All memory - Power On holding RESET + DELETE keys with PWE=1
Delete Parameters - Power On holding RESET key with PWE = 1
Delete Programs - Power On holding DELETE key with PWE = 1

You might also like