Scribd
Upload
29 views1 page

DAILY (Frequent) Overhead Crane/Hoist Inspection Checklist: 4.0/3b10e021.pdf 1 (11/2006)

This document provides a checklist for inspecting overhead cranes/hoists on a frequent basis. The checklist includes items to check such as the inspection tag, pendant/controller functions, wire rope/chain for damage, hooks, limit switches, brake systems, travel paths, gearing systems, rails, lubrication, weight limits, and rigging equipment. Operators are instructed to stop using cranes/hoists if any malfunctions or unusual noises are observed and to contact their supervisor.

Uploaded by

jayabal_spm
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
29 views1 page

DAILY (Frequent) Overhead Crane/Hoist Inspection Checklist: 4.0/3b10e021.pdf 1 (11/2006)

This document provides a checklist for inspecting overhead cranes/hoists on a frequent basis. The checklist includes items to check such as the inspection tag, pendant/controller functions, wire rope/chain for damage, hooks, limit switches, brake systems, travel paths, gearing systems, rails, lubrication, weight limits, and rigging equipment. Operators are instructed to stop using cranes/hoists if any malfunctions or unusual noises are observed and to contact their supervisor.

Uploaded by

jayabal_spm
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DAILY (Frequent)

OVERHEAD CRANE/HOIST INSPECTION CHECKLIST

Dept/Div: Crane #: Bldg #: Date:

Operator Name: Life #:

Check BNL Periodic Inspection Tag


NOTE: If the tag is missing or the inspection due date has expired or is illegible,
the equipment must be removed from service. Contact the BNL Hoisting and Rigging
Inspector at ext. 5456 to schedule an inspection.

Locate Crane Main Disconnect Switch

Check Pendant Controls or Controllers or Selector


(Up, Down, East, West, North and South)

Check Wire Rope or Chain for Damage *Documented 30-Day inspection required
(check rope/chain for worn, cut, kinked crushed, spooling, or birdcaged cable)

Check Hook *Documented 30-Day Inspection required (Bent, spread, cracked, and
safety latch)

Check Upper Limit Switch (Hook block stop)

Check for Reverse Reeving (Hoist cable direction)

Check Brake System (Trolley, bridge, and hoist)

Check Trolley and Bridge Travel (Make sure stops are in place and limits working
Make sure travel path is clear of obstructions)

Check Hoist Gearing System (Any unusual noises)

Check Rails During Operation (Unusual wear or noise)

Check Lubrication (Leaks, excess grease)

Review Weight Limits


(Weight to be lifted must be calculated or measured if unknown)

Inspect Rigging Equipment to be Utilized


(Slings, shackles, guide ropes, use personnel protection equipment)

CAUTION: IF ANY MALFUNCTIONS OR UNUSUAL NOISES ARE


OBSERVED, STOP USING THE CRANE/HOIST AND CONTACT YOUR
SUPERVISOR OR SAFETY COORDINATOR IMMEDIATELY

NOTE: PERSONNEL USING MATERIAL HANDLING EQUIPMENT


MUST BE TRAINED AND QUALIFIED FOR THAT SPECIFIC TYPE OF EQUIPMENT

4.0/3b10e021.pdf 1 (11/2006)

You might also like