Scribd
Upload
59 views

Spurious Emissions Are Emissions, Which Are Caused by Unwanted Transmitter

This document discusses co-location and isolation requirements between different wireless technologies. It provides examples of isolation needs between a UMTS downlink and uplink due to spurious emissions and between transmission points due to receiver blocking. Intermodulation performance is also addressed. Key issues discussed are co-location problems for base station receivers and mobile receivers from spurious emissions and blocking. Vendors can provide better isolation specifications than 3GPP standards. Proper isolation requires considering equipment specs, antenna separation both horizontally and vertically, additional filtering, antenna beamwidth, bearing, frequency coordination, and smart antenna designs.

Uploaded by

Anuj Thakur
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
59 views

Spurious Emissions Are Emissions, Which Are Caused by Unwanted Transmitter

This document discusses co-location and isolation requirements between different wireless technologies. It provides examples of isolation needs between a UMTS downlink and uplink due to spurious emissions and between transmission points due to receiver blocking. Intermodulation performance is also addressed. Key issues discussed are co-location problems for base station receivers and mobile receivers from spurious emissions and blocking. Vendors can provide better isolation specifications than 3GPP standards. Proper isolation requires considering equipment specs, antenna separation both horizontally and vertically, additional filtering, antenna beamwidth, bearing, frequency coordination, and smart antenna designs.

Uploaded by

Anuj Thakur
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

Co-location, Isolations

Spurious emissions are emissions, which are caused by unwanted transmitter


effects such as harmonics emission, parasitic emission, intermodulation
products and frequency conversion products, but exclude out of band
emissions. This is measured at the base station RF output port.

Spectrum Emission Mask, 3GPP TS 25.104 Fig. 6.2

Spurious emissions limits for protection of the BS receiver

The table above corresponds to -80 dBm / 3.84MHz spurious emission


requirements from UMTS DL to UMTS UL.

EXAMPLE

Spurious emission DL to
- 80 dBm See above
UL
Max sensitivity - 121 BS reference
degradation dBm sensitivity
Min required isolation 41 dB

UMTS FDD isolation requirement due to spurious emissions


Note: Check with your vendor, they will quote a lower figure

The receiver blocking characteristics is a measure of the receiver ability to


receive a wanted signal at its assigned channel frequency in the presence of an
unwanted interferer on frequencies other than those of the adjacent channels.

EXAMPLE

Max Node B power 43 dBm = 20W


Blocking level - 40 dBm 3GPP 25104 7.5.1
Min required isolation 83 dB

UMTS FDD - FDD isolation requirement due to receiver blocking


Note: Check with your vendor, they will quote a lower figure

The transmit intermodulation performance is a measure of the capability of


the transmitter to inhibit the generation of signals in its non linear elements
caused by presence of the wanted signal and an interfering signal reaching the
transmitter via the antenna. The transmit intermodulation level shall not exceed
the out of band emission or the spurious emission requirements.

Summary: Co-location and isolation related issues


Co-location issues; base station receivers; spurious emission and blocking
 Co-existence issues; mobile phone receivers; spurious emission and
blocking
 Intermodulation issues
 All wireless systems need to be considered
 Vendor equipment specification far better that 3GPP specifications

Solution considerations
 Equipment specifications
 Horisontal antenna separation
 Vertical antenna separation
 Additional filtering
 Antenna beamwidth
 Antenna bearing
 Frequency coordination with other carriers
 Smart designs for common antenna systems

You might also like