0% found this document useful (0 votes)
1K views2 pages

Interface XBee Module With PIC Microcontroller

The document provides an overview of how an XBee module communicates with a microcontroller. It states that the XBee receives power through its 5V and ground pins and transmits and receives data through its TX and RX pins. It also notes that the XBee connects to the microcontroller's UART pins for communication and can be added to a microcontroller circuit by soldering it above the circuit board using female headers.

Uploaded by

guessmeocean
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
1K views2 pages

Interface XBee Module With PIC Microcontroller

The document provides an overview of how an XBee module communicates with a microcontroller. It states that the XBee receives power through its 5V and ground pins and transmits and receives data through its TX and RX pins. It also notes that the XBee connects to the microcontroller's UART pins for communication and can be added to a microcontroller circuit by soldering it above the circuit board using female headers.

Uploaded by

guessmeocean
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

c

  

   

5V and ground is connected to provide power to the module. While TX and RX pin is connected
for communication. JP1 jumper is connected at COM for interfacing SKXBEE.

Below is the system overview on how XBee communicate with microcontroller. The XBee will
connected to the microcontroller via Universal Asynchronous Receiver/transmitter (UART) pins.

SKXBEE can be add on in the microcontroller circuit. It will lifted a bit high from microcontroller
circuit or in other words above the microcontroller circuit. All we need to used is a female
header.
c

You might also like