Scribd
Upload
145 views1 page

Readme

1. Install the license manager and leave the license file path blank. Copy the license manager files and overwrite. 2. Open the license file, replace the computer name, and save. Run setup again and enter the license file path. 3. Run setup again, enter the port and computer name, select apps, and leave other paths blank. Start the license manager server and reread the license file.

Uploaded by

Per Perso
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
145 views1 page

Readme

1. Install the license manager and leave the license file path blank. Copy the license manager files and overwrite. 2. Open the license file, replace the computer name, and save. Run setup again and enter the license file path. 3. Run setup again, enter the port and computer name, select apps, and leave other paths blank. Start the license manager server and reread the license file.

Uploaded by

Per Perso
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

1. Install the license manager first by choosing Set Up Licensing from setup.

exe
. Donot enter any paths. for license file. Leave it blank.
2. Copy the contents of license_manager from SHooTERS folder to installed dir C:
OrCADlicense_manager. Overwrite files.
3. Open orcad16.lic (stored on the hard drive not from the CD) in text editor an
d replace this_host with the name of the Computer (in the first line of the file
), and save the file.
4. Run setup again and choose Set up License and enter the path of license file
C:OrCAD\license_manager\orcad16.lic .Click Next. Ignore the failure error and pr
ess Cancel.
5. Run setup again, and choose Install products, enter port as 5280 and host id/
name as the name of your Computer. Next select the apps you want to install. Lea
ve the installinfo and contr.. file paths blank.
6. After the installation is completed, go to Start->Programs->Cadence License M
anager->License Manager Tools and change the path of license file to
C:OrCAD\license_manager\orcad16.lic in the Config Services tab. (it would be som
e license.dat initially)
7. Click on Start Server button in the Satrt/Stop/Reread tab of the license mana
ger utility. Next click on Reread License File. Wait for the reread operation to
be completed (see status bar).
8. Now check if the Cadence License Manager service is running in the Control Pa
nel->Administrator Tools->Services.
9. Run orcad_16.0_patcher.exe.
10. Done
If you get the ERROR message "The procedure entry point RWSetO2K3Color could not
be located in the dynamic link library RWUXThemeS.dll", go in to environment va
riables and move the link "%CDSROOT%\tools\bin" in the Path variable to the begi
nning of it.

You might also like