Scribd
Upload
171 views

Hennig ChipConveyorWorksheet

This document is a worksheet for quoting a Hennig Chip Conveyor or Chip Disc Filtration system. It requests contact information for the customer as well as technical specifications about the machine the conveyor or system will be used for, including horsepower, chip volume, type of chips, discharge location, and coolant details. Completing this worksheet provides the necessary information for Hennig to generate a quotation.

Uploaded by

rajeevvshishodi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
171 views

Hennig ChipConveyorWorksheet

This document is a worksheet for quoting a Hennig Chip Conveyor or Chip Disc Filtration system. It requests contact information for the customer as well as technical specifications about the machine the conveyor or system will be used for, including horsepower, chip volume, type of chips, discharge location, and coolant details. Completing this worksheet provides the necessary information for Hennig to generate a quotation.

Uploaded by

rajeevvshishodi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Chip Conveyor Worksheet

To begin the quotation process for a Hennig Chip Conveyor or Hennig Chip Disc Filtration (CDF) system,
please complete this interactive PDF or print this form, fill in all fields, and fax to 815-636-9737.

1 Company (complete address)


Your Name

E-Mail
Phone
Fax

2 Technical Data
1. Intake length LI = mm 16. Machine make and model
2. Max length L= mm 17. Type of machine Lathe Milling

3. Discharge height H= mm Drilling Tapping


4. Max width W= mm Other:
5. Angle (45°, 60°) A= deg. 18. Spindle H.P. hp
6. Foot location (choose one) B= mm 19. Chip volume in3/min
C= mm 20. Chip type Cast Iron Steel

7. Width of chip chute WI = mm Aluminum Brass

8. Height of chip chute HI = mm Other:

9. Power requirements V Ph Hz 21. Kind of chips Fine Broken

10. Control box (check all that apply) Yes No Lg Broken Lg Bushy

Std 3 button (forward, reverse, stop) Yes No Tight Bushy

On/off switch (no starters/overloads) Yes No 22. Discharge location Side Front Rear

Variable speed option Yes No 23. Coolant tank Yes No


Special (provide specs) 24. Height/Width/Length / / mm
11. Paint Grey Blue 25. Tank capacity Gallons
Other (paint chip required) 26. Coolant flow rate
(Total machine) Gal/min
12. Casters Yes No 27. Coolant pumps GPM @ psi
13. Motor location Left Right 28. Float switch Yes No
14. Filtration spec microns

15. Coolant slots (conveyor only) Yes (location) No


Left Right Both

You might also like