Scribd
Upload
56 views

Is Ok8601

This document provides installation instructions for a light fixture in 7 steps: 1. Unpack and identify all parts. 2. Turn off power at the circuit breaker. 3. Secure the universal crossbar to the outlet box with screws. 4. Make electrical connections between house and fixture wires. 5. Tuck wires into the outlet box and secure the fixture with mounting screws and balls. 6. Position the shade and socket and secure with a collar. 7. Install bulbs and restore power.

Uploaded by

dayshift5
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
56 views

Is Ok8601

This document provides installation instructions for a light fixture in 7 steps: 1. Unpack and identify all parts. 2. Turn off power at the circuit breaker. 3. Secure the universal crossbar to the outlet box with screws. 4. Make electrical connections between house and fixture wires. 5. Tuck wires into the outlet box and secure the fixture with mounting screws and balls. 6. Position the shade and socket and secure with a collar. 7. Install bulbs and restore power.

Uploaded by

dayshift5
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

INSTALLATION INSTRUCTIONS

6 CORPORATE PARKWAY
GOOSE CREEK , SC . 29445
www . quoizel . com 1. Before beginning the installation, carefully unpack and identify all parts ,
referring to illustration.

2 . Turn the electrical power to installation point OFF at circuit breaker .


BACKPLATE 3 . Locate the UNIVERSAL CROSSBAR and secure to OUTLET BOX with
( 2 ) OUTLET BOX SCREWS ( not supplied ) .
UNIVERSAL
CROSSBAR (2) OUTLET
BOX SCREWS
4. Make the connections: Use wire connectors(not supplied) connect the
OUTLET BOX (not supplied) HOUSE GROUND to the FIXTURE GROUND WIRE ; attach the HOUSE
WHITE WIRE to FIXTURE WHITE (or RIBBED SIDE) SUPPLY WIRE;
connect the HOUSE BLACK (or RED) WIRE to the FIXTURE BLACK(or
SMOOTH SIDE) WIRE. Wrap each connection with approved electrical
tape.

5. Carefully tuck all wires into the WALL MOUNTED OUTLET BOX and
position the fixture over the outlet box. Align the HOLES in the BACKPLATE
(2) MOUNTING SCREWS with the ( 2 ) MOUNTING SCREWS attached to the UNIVERSAL
SOCKET
CROSSBAR. Pass the fixture over the ( 2 ) MOUNTING SCREWS and
secure against by threading ( 2 ) MOUNTING BALLS onto end of screw.
Tighten until snug.

FIXTURE SUPPLY WIRE 6. Position SOCKET through the hole on the bottom of SHADE. Use
and GROUND WIRE
SPANNER(included), thread SOCKET COLLAR onto SOCKET and hand
tighten until snug to secure SHADE.
( 2)MOUNTING BALLS
7. Install bulb(s) referring to fixture markings and/or labels for
SHADE
maximum wattage.

8 . Restore power to the installation point ON. Retain this sheet for future
SOCKET COLLAR reference.

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,


SPANNER
(included)
CONSULT A LICENSED ELECTRICIAN!

IS - OK8601
2006-9-21

You might also like