Scribd
Upload
174 views3 pages

How Wait and Weight Method Controls Bottom Hole Pressure

This document explains how the wait and weight method controls bottom hole pressure during well killing operations. There are two steps: 1) displacing kill weight mud to the bit, where drill pipe pressure is decreased according to a schedule to balance bottom hole pressure as hydrostatic pressure increases; and 2) displacing kill weight mud from the bit to surface, where drill pipe pressure must be maintained to keep bottom hole pressure constant, since there is now a single hydrostatic column. The key is using drill pipe pressure to compensate for changing hydrostatic pressures in order to maintain a stable bottom hole pressure throughout the operation.

Uploaded by

Abhi Sharma
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
174 views3 pages

How Wait and Weight Method Controls Bottom Hole Pressure

This document explains how the wait and weight method controls bottom hole pressure during well killing operations. There are two steps: 1) displacing kill weight mud to the bit, where drill pipe pressure is decreased according to a schedule to balance bottom hole pressure as hydrostatic pressure increases; and 2) displacing kill weight mud from the bit to surface, where drill pipe pressure must be maintained to keep bottom hole pressure constant, since there is now a single hydrostatic column. The key is using drill pipe pressure to compensate for changing hydrostatic pressures in order to maintain a stable bottom hole pressure throughout the operation.

Uploaded by

Abhi Sharma
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

How wait and weight method controls bottom hole pressure

This topic will explain you how wait and weight well control controls bottom pressure constant.
There are 2 steps that must be took into consideration separately. The first one is when kill
weight mud is displaced to the bit and the second one is when the kill weight mud from bit to
surface.

1) Displace kill weight mud to the bit

Once kill weight mud is mixed and displaced into drill pipe, drill pipe pressure will be decreased
due to increasing in hydrostatic pressure. In order to control bottom hole pressure, a drill pipe
pressure schedule must be developed and followed until kill mud weight to the bit.

Take a look at the equation:

Pressure in drillpipe side = BHP = Pressure in casing side

DPP + HP – Frictional P in drillstring = BHP = HP + CP + Frictional P in annulus

Where:

DPP is drill pipe pressure.


HP is hydrostatic pressure.

Frictional P is frictional pressure.

CP is casing pressure.

At drillpipe side:

DPP will drop when kill mud weight is displaced.

HP will increase due to kill mud weight in the drillstring.

Friction P in drillstring will not change so much.

At casing side:

HP will decrease due to gas expansion in the annulus.

CP will increase in order to compensate hydrostatic pressure loss.

Frictional P in annulus had minimal effect on bottom hole pressure due to slow flow rate while
killing the well.

2) Displace kill weight mud from bit to surface

Once the kill weight mud comes out of the bit, there is one single column of hydrostatic in the
drillstring. Therefore, in order to maintain bottom hole pressure constant, drill pipe pressure
must be maintained while displacing.

 
 

Conclusion:

• Use the drill pipe pressure schedule to control constant bottom hole pressure while displacing
kill weight mud to the bit.

• After kill mud out of the bit, maintain drill pipe pressure until circulation complete.

You might also like