Scribd
Upload
721 views

Error Code b001

The document provides troubleshooting steps for resolving issues receiving signals from a DTH (Direct-to-Home) satellite TV service. It describes that the problem lies with the antenna receiving the signal from the satellite dish, not with the signal strength itself. Adjusting the small black protruding object on the antenna where the cable connects to the setup box by rotating it clockwise or counter-clockwise can help resolve the issue by ensuring the middle arrow is pointing to the center point. Resetting the setup box configuration may also help if signal quality is sufficient but no picture is being received.

Uploaded by

Swathi Bhat
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
721 views

Error Code b001

The document provides troubleshooting steps for resolving issues receiving signals from a DTH (Direct-to-Home) satellite TV service. It describes that the problem lies with the antenna receiving the signal from the satellite dish, not with the signal strength itself. Adjusting the small black protruding object on the antenna where the cable connects to the setup box by rotating it clockwise or counter-clockwise can help resolve the issue by ensuring the middle arrow is pointing to the center point. Resetting the setup box configuration may also help if signal quality is sufficient but no picture is being received.

Uploaded by

Swathi Bhat
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

I am able to resolve the issue.

It has come twice, Once the Airtel DTH ( ADTH ) guy came second time I was able to resolve it myself. diagnose: you can diagnose if you are at this issue or not ? Signal Quality -- ( > 197 ) Signal Strength -- ( > 20 ) And you are not receiving the signals just black screen with program info or 108, 283, 284 -- channel says error code B001..

Then the whole problem lies in the Antenna. Antenna has a dish and the some small black protruding on a stick outside the antenna where the cable is connected to setup box. The signal sent by satellite is received by the dish and reflected back to be captured at the black protruding object on a stick outside the antenna where the cable is connected to setup box. Now the signal is captured by this black object and sent through cable to the setup box. Here lies the problem the dish is capturing the signals as seen by the signal quality and the strength. But the problem lies in the signal being received to setup box through black protruding object on a stick outside the antenna where the cable is connected to setup box. Hence the black object attached to stick need to be rotated. it has some lines on it which can be rotated clock or anti-clockwise. Now adjust this black round plastic object anti-clockwise or clockwise such that the middle arrow in the black is pointing to the center of the point shown on the fixed black object.

If the signal strength/quality is low, then first you have to adjust the dish to get the proper signal strength and the quality. If all the above seems to be correct then you must reset the setup box. Using the following instruction: I have tryed resetting the setup box .... I used the following procedure back+menu+right+down button to reset the setup box.. seen till the message sign starts blinking... then I restarted the setup box. i followed the installation instruction for Airtdel DTH ( ADTH) for setup box reset : chose instruction as : English Transponder settings: INSAT4CR TP1-1 then signal setting : signal level : 201 BER : 10-20 LNB settings: LNB Type -- dual band LNB Number -- 1 Satellite -- Insat-4CR IO Low freq -- 09750 IO High freq -- 10600 DiSEqC Mode -- DiSEqC A

You might also like