Scribd
Upload
25 views

Disc Spring-Symbols & Units

1. The document discusses the symbols and units used for disc springs as per DIN 2093 standards. 2. Disc springs are classified into 3 groups based on the thickness of a single disc - group 1 is less than 1.25mm, group 2 is between 1.25-6mm, and group 3 is over 6mm up to 14mm. 3. The symbols and units defined include outside diameter, inside diameter, mean diameter, modulus of elasticity, spring load, formed height, free overall height, deflection, thickness, reduced thickness, design stresses, relaxation and more.

Uploaded by

latshare
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
25 views

Disc Spring-Symbols & Units

1. The document discusses the symbols and units used for disc springs as per DIN 2093 standards. 2. Disc springs are classified into 3 groups based on the thickness of a single disc - group 1 is less than 1.25mm, group 2 is between 1.25-6mm, and group 3 is over 6mm up to 14mm. 3. The symbols and units defined include outside diameter, inside diameter, mean diameter, modulus of elasticity, spring load, formed height, free overall height, deflection, thickness, reduced thickness, design stresses, relaxation and more.

Uploaded by

latshare
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

DISC SPRING : SYMBOLS & UNITS Symbols and Units : Standard sizes available as per DIN 2093 Group

Classification of Disc springs

In accordance with DIN 2093 Standard, Disc Springs are classified into 3 groups as given in the table: Group Thickness of single disc in mm less than 1.25 From 1.25 to 6 Over 6 upto 14

Single disc with Ground ends & reduced material thickness (t')
No No Yes

1 2 3

Symbol De Di

Unit mm mm mm N/mm2

Term Outside diameter Inside diameter Mean diameter Modulus of elasticity Spring load of a single disc (with or without front ends) Formed height

Symbols and Units

Symbol lo s t t1

Unit mm mm mm mm

Term Free overall height of spring in its initial position Deflection of single disc Thickness of single disc Reduced thickness of single disc in the case of springs with ground ends (group 3) Poisson's ratio

Do E

ho

mm

OM,ol,oil, III, & IV, F

Design stresses at the points designated OM, I, II, N/mm2 III, and IV (see figure) N Relaxation

62215629.doc

Page 1 of 1

You might also like