Scribd
Upload
84 views

Fuzz Face

The document provides circuit diagrams and instructions for building two versions of a fuzz face pedal - one using PNP germanium transistors and the other using NPN silicon transistors. The PNP version is shown but the 470 ohm resistor must be changed to 330 ohms and the battery and capacitor polarities reversed for the NPN version. Minor component variations are possible between units but the schematic captures the essential design.

Uploaded by

Fernando Mendoza
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
84 views

Fuzz Face

The document provides circuit diagrams and instructions for building two versions of a fuzz face pedal - one using PNP germanium transistors and the other using NPN silicon transistors. The PNP version is shown but the 470 ohm resistor must be changed to 330 ohms and the battery and capacitor polarities reversed for the NPN version. Minor component variations are possible between units but the schematic captures the essential design.

Uploaded by

Fernando Mendoza
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Fuzz Face

Dallas Arbiter
470* 0.1uf 9v + Q2 2.2uf IN
1/2

33k

8.2k

500k
1/2

S1 OUT

Q1

S1 100k 20uf 1k
+

There are apparently two similar versions of the fuzz face. In one Q1 and Q2 were PNP germanium AC128 or NKT275 types in the other they were NPN sillicon BC108C types. Now depending on which type you choose to build will influence some of the other components. For a PNP version the schematic is as shown, but if you build the NPN version then the 470 ohm resistor marked by a * must be changed to 330 ohms and the battery and all the polarized capacitors must be reversed. The original schematic is not exaclty what is shown above, it had a very complex switching system which has been simplified (nothing has been lost dont worry) and a unique grounding setup. Aside from that the schem is exact with minor differences in components on various units (eg. some had the 0.1uf cap listed as .047uf, which shouldnt make a difference as long as you feed a high impedance amp). The transistors are hard to find, the thing to look for is germanium transistors with a decent gain factor (gain > 80). Note silicon transistors will clip harshly and may not sound good, though 2n3906 has been said to work.

You might also like