Scribd
Upload
33 views

Crack

The document describes how to crack the password on a Cisco router and Catalyst 2950 switch. For the router, it involves changing the configuration register, resetting it to bypass the password check, then changing the register back and saving the configuration. For the switch, it involves connecting via console cable, renaming the configuration file, removing the enable password and secret, then saving to not require a password on next startup.

Uploaded by

Triet Constantine
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
33 views

Crack

The document describes how to crack the password on a Cisco router and Catalyst 2950 switch. For the router, it involves changing the configuration register, resetting it to bypass the password check, then changing the register back and saving the configuration. For the switch, it involves connecting via console cable, renaming the configuration file, removing the enable password and secret, then saving to not require a password on next startup.

Uploaded by

Triet Constantine
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Crack pass ca Router CISCO

Tt bt li router say khong 15 giy. Bm t hp phm Ctrl+Break. Route s vo mode Rommom.

Rommom1>confreg 0x2142 (thay i cu trc thanh

ghi thnh 2142) Rommom2>reset (khi ng li router) Router s b qua giai on kim tra pass. Khi router khi ng li xong phi thay i li pass mi. Thay i li cu trc thanh ghi li thnh 2102 (Router(config)#config-register 0x2102)

Lu li file cu hnh.

Crack pass Switch: 1. Connect computer to the catalyst 2950 Switch using console cable. 2. Plug console cable RJ-45 side into console port at back of the Switch, and DB-9 side 3. 4. 5. 6. 7. 8.
into serial port at back of computer. Plug the power cable at back of the Switch, and Holding "mode" button at left corner of the front panel for 15 seconds In Windows XP,click "Start" menu,and then move to "Accessories"--->"Communications"---->"Hyper Terminal" The system has been interrupted prior to initializing the flash file system,and it wills show the following information. In command line, type "rename flash:config.text flash:config.old", it will rename the "config.text" configuration file in flash directory as "config.old". after rename, it will not boot from config.old In command line, type"boot". it will restart operating system and show the following information: In command line, type"boot". it will restart operating system and show the following information: Enter "n" at the prompt to start the Setup program. In command line, type "enable", it will enable privilege mode.

9. 10. 11. type"rename flash:config.old flash:config.text" after "switch#_". 12. type"copy flash:config.text run" in command line. it will copy the configuration to the current
running-config file

13. type"conf t" in command line , it will enable configuration terminal. 14. type"no enable password" in command line , it will remove password 15. type"no enable secret" in command line, it will remove secret 16. type"line console 0" in command line. it changes to the console 0 17. type"no password" in command line. it means do not set password for console 0 18. type"end" in command line. it will save and quit config terminal mode 19. type"write" in command line, it saves the configration file to running-config file. when
next time start the switch, there is no password required

You might also like