Scribd
Upload
24 views

Dr. N.G.P. Institute of Technology: Department of Electronics and Communication Engineering

The document summarizes the design and implementation of an energy feedback digital device used in elevators. It includes a block diagram and work plan with multiple phases and modules. The phases include feedback path simulation, temperature/voltage detection, regenerating power using multilevel inverters, and constructing protection circuits. The work completed so far includes simulation of the entire system and building part of a protection circuit using a PIC controller and RTD sensor.

Uploaded by

jcpradip
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
24 views

Dr. N.G.P. Institute of Technology: Department of Electronics and Communication Engineering

The document summarizes the design and implementation of an energy feedback digital device used in elevators. It includes a block diagram and work plan with multiple phases and modules. The phases include feedback path simulation, temperature/voltage detection, regenerating power using multilevel inverters, and constructing protection circuits. The work completed so far includes simulation of the entire system and building part of a protection circuit using a PIC controller and RTD sensor.

Uploaded by

jcpradip
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 12

Dr. N.G.P.

INSTITUTE OF TECHNOLOGY

DEPARTMENT OF ELECTRONICS AND COMMUNICATION ENGINEERING


DESIGN AND IMPLEMENTATION OF AN ENERGY FEEDBACK DIGITAL DEVICE USED IN ELEVATOR

Guided by, Ms.Priyadarshini M.E.,

Presented by, Sarun.S (080107105083) Sruthirag.R (080107105099) Vaisakh Mohan (080107105109) Sri Rakesh.M(090407105013)

Block diagram

Work Plan
Project Phase
Phase I
Phase II

Modules
Module 1
Module 2 Module 3

Completion of Work
Feedback Path of inverter using Simulation
Temperature & voltage detection Regenerating power using Multilevel inverters

Module 4

Constructing protection circuits

Project Phase-I (11-10-11), Dr.N.G.P. IT

Specification Of RTD

Simulation Circuit

Output voltage

Motor output power

Regenerative power to grid

Out put active power from motor

Hardware snapshot

Work completed
Simulation part of our entire project is completed. A part of protection circuit is built using PIC controller and RTD sensor.

References
1. K.Sundareswaran, An improved energy-saving scheme for capacitor run induction motor, IEEE Trans. Ind. Electron., vol. 48, no.1, pp. 238240, Feb. 2001. 2. S.Tominaga, I.Suga, I.Araki, H.Ikejima, M.Kusuma, and K.Kobayashi, Development of energy-saving elevator using regenerated power storage system, Jpn. Soc. Power Electron., vol. 27, no. 1, pp. 890895, 2001, JSPE-27-5. 3. M. C. Chandorkar, New technique for inverter flux control, IEEE Trans. Ind. Appl., vol. 37, no. 3, pp. 880887, May/Jun. 2001.

4. J. C. Rosas-Caro, F. Z. Peng, H. Cha, and C. Rogers, Z-source converter based energy recycling zero-voltage electronic loads, IEEE Trans. Ind. Electron., vol. 56, no. 12, pp. 48944902, Dec. 2009.

You might also like