Scribd
Upload
31 views

Ring Sizing

There are two methods provided to measure ring size. Method A involves cutting out and using the included ring sizer template to wrap around the finger and read the corresponding size. Method B involves selecting a ring that fits and matching its inner edge to the sized circles printed to determine millimeter and numeric size. The document provides tips for getting an accurate measurement, such as measuring in the morning before fingers swell.

Uploaded by

kayanna24
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
31 views

Ring Sizing

There are two methods provided to measure ring size. Method A involves cutting out and using the included ring sizer template to wrap around the finger and read the corresponding size. Method B involves selecting a ring that fits and matching its inner edge to the sized circles printed to determine millimeter and numeric size. The document provides tips for getting an accurate measurement, such as measuring in the morning before fingers swell.

Uploaded by

kayanna24
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Ring Sizing Guide

*Sizes & dimensions are approximate.

Make sure your printer is set to 100-percent. Do not reduce the print size in your printer page setup area. You can verify that the ring sizer printed correctly by measuring it with a ruler; it should measure 3 1/2 inches long from "A" to "B". To open the print dialog box, press CTRL + P for pc or COMMAND +P for mac.

Method A: Measure Your Finger

1. Cut out the ring sizer. 2. Cut a slit for Slot "A". 3. Wrap the sizer around the finger where the ring will be worn. Make sure the numbers are facing out. 4. Pull the pointed end Tab "B" through Slot "A"until the sizer is snug. Make sure to allow size for your knuckle. If your knuckle is size in between the two. 5. The number aligned with Slot "A" is your ring size. 6. If the measurement lands between two numbers, your size is a half size. Example: If your measurement falls between 5 and 6, your ring size is 5 1/2.

Use a quarter to make sure this page is printed at the correct size.

Sizing Tip: Measure your finger at the beginning of the day to avoid incorrect measurements. More sizing mistakes are made by ordering rings too large rather than too small.

Read Size Here

Method B: Measure a Ring that Fits


1. Select a ring that properly fits the intended finger. 2. Place the ring on top of the circle below until the inside edge of the ring matches the outside of the circle. Comfort Fit Ring Tip: If the ring is a comfort fit design, match circles to the contoured edge of the inner surface of the ring.

Size 4.5 14.8 mm

Size 5 15.6 mm

Size 5.5 16 mm

Size 6 16.45 mm

Size 6.5 16.9 mm

0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

3 Inches

Size 7 17.3 mm

Size 7.5 17.7 mm

Size 8 18.2 mm

Size 8.5 18.6 mm

Size 9 19 mm

Size 9.5 19.4 mm

Size 10 19.9 mm

Size 10.5 20.2 mm

Size 11 20.6 mm

Size 11.5 21 mm

Size 12 21.4 mm

Size 12.5 21.8 mm

Size 13 22.2 mm

You might also like