0% found this document useful (0 votes)
687 views40 pages

QRX 7500

This service manual is designed for service engineers to repair, parts of the QRX-7S00 and parts name ordering the parts, use the stock number of the unit, please refer to the adjust, maintain and order the replacement correctly.

Uploaded by

hostile89
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
687 views40 pages

QRX 7500

This service manual is designed for service engineers to repair, parts of the QRX-7S00 and parts name ordering the parts, use the stock number of the unit, please refer to the adjust, maintain and order the replacement correctly.

Uploaded by

hostile89
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 40
“nV aie eee MANUAL 4-CHANNEL RECEIVER SANSUI QRX-7500 Bra SANSUI ELECTRIC CO., LTD. ‘QRX.7500 This service manual is designed for service engineers to repair, adjust, maintain and order the replacement parts of the QRX-7500 correctly. When ordering the parts, use the stock number and parts name specifically referring to the Parts Locations & Parts List, For general usage and maintenance of the unit, please refer to the Operating Instructions attiched with the unit TABLE OF CONTENTS. Section Tile Page 1. SPECIFICATIONS 2 2. BLOCK DIAGRAM AND VALUE OF EACH LEVEL. 34 3. ALIGNMENTS AND ADJUSTMENTS: 5 3-1. Regulated Power Supply Board Adjustment 5 3-2 Level Meter Adjustment 5 33. Driver Circuit Board Adjustment 6 3-4 FMIF Alignment 7 35. FM Dial Calibration and RF Alignment 8 36. FM Signal Meter, Mono Distortion, Tune Meter and Muting Adjustment. - 8 37. MPX Alignment 8 3-8 AMIF, Dial Calibration, RF and Signal Meter Alignment .-..9, 10 4. THREADING OF DIAL CORD ...... a 5. TROUBLESHOOTING CHART u 5-1. Troubleshooting on Power Suoply Section. u 5-2. Troubleshooting on Audio Section. 11, 12,13 53. Troubleshooting on RF Section 13, 14,15 6. PARTS LOCATIONS AND PARTS LIST 16 6-1. F-1484 Tone Control Circuit Board 16 6:2. F-1490 De-emphasis Circuit Board. 16 63. F-1479A Tuner Circuit Board 17, 18,19 6-4. F-1515 Protector & Power Circuit Board 19,20 65. F-2048 Vario-Matrix Circuit Board 21, 22 6-6. F-2047 Vario-Matrix Circuit Board. 23,24 6-7. F-1485 Meter Circuit Board 24 6-8 F-1514 Driver Circuit Board 25,26 63. F-1516 Accessory Circuit Board 26 6-10. F-1487 Volume Circuit Board 26 6-11. F-1488 Connector Joint Circuit Board 27 6-12. F-1486 Filter Circuit Board = 27) 6-13. F-2085 Equalizer & CD-4 Main Circuit Board 28 6-14-2090 CD-4 Sub Channel Unit Circuit Board. £128, 30 6-15. Other Parts (Front Side) . ‘31, 32 6-16. Other Parts (Top Side) 33 6-17. Other Parts (Battom Side) 34 7. PACKING LIST 35 8. ACCESSORY PARTS LIST 35 9.. SCHEMATIC DIAGRAM OF TUNER SECTION 36 10. SCHEMAITC DIAGRAM OF AUDIO SECTION 37,38 yuo 1. SPECIFICATIONS AUDIO SECTION POWER OUTPUT (at rated distortion) MUSIC POWER (IHF)......260W (42 1,000Hz) 180W (82 1,000Hz) CONTINUOUS POWER Each Channel Driven ..52W x4 (402 1,000HHz) 35W x4 (80 1,000H2) 4-Channels Driven...28+28-+28+28W (80. 1,000H2) 25-425 +25-+25W_ (8a 20 to 20000H2) 2-Channel Operation 2-channel driven) 32+32W (8A 1,000H2) TOTAL HARMONIC DISTORTION (at rated power output) OVERALL (from 4-CHANNEL AUX) less than 0.39% INTERMODULATION DISTORTION (at rated power out- put 70Hz:7,000H2=4:1 SMPTE method) (OVERALL (from 4-CHANNEL AUX) less than 0.3% POWER BANDWIDTH (IHF)..10 to 30,000Hz LOAD IMPEDANCE 4 t0 160 DAMPING FACTOR 40 (60) INPUT SENSITIVITY AND IMPEDANCE (1,000Hz forrated power outpud 2:CHANNEL PHONO, 2, Bm SOKA {Sox input capably, Ibm trated distortion) 2CHANNEL TAPE PLAY Pin Jacks... 100m 80k RECIPLAY DIN Socket = 100m SOK. A-CHANNEL AUXCLOW. -Om\ kA AUKHIGH 200m 00402 acuanwet TAPE 2 PLAY Pin Jacke >... 10OmV $00, RECORDING OUTPUT CHANNEL TAPE REC Pin Jacks tomy RECIPLAY DIN Socket | 30m A-CHANNELTAPEN, 2 REC Pin Jacks >... 10OmV FREQUENCY ReSPONSE (at 1 Watt output) OVERALL (fom 4-cHANNEL AU) 30 to 300002 #3548 EQUALIZATION (RIAA curve) 30 to 15,000Hz + 1.0d8 CROSSTALK (FUNCTION contral:2°CH. 1004) better than 50dB HUM AND NOISE (HF) 2-CHANNEL PHONO. better than 70d8 4-CHANNEL AUX better than 80d8 SWITCHES AND CONTROLS BASS «os... +12dB, —12d8 at SoFz TREBLE». $1248, ~12d8 at 15,000Hz LOUDNESS «- +808 at 50H, +3dB at 10,000H2 LOW FILTER «02.2.4. —10dB at SOHz (6dB/oct) HIGH FILTER —10d8 at 10,000Hz (6dB/oct) SYNTHESIZER/DECODER ....Q5 regular matrix system with QS vario-mateix elt cuit (CD-4 DEMODULATOR Input Sensitivity. .......2.5mV (1 to 10mV adjustable) Input impedance... S0kn, Freguency Response (STD test signal) ‘Main-Channel 30 to 15,000H2!254e Sub-Channel ......--30 to 10000H22! 248 TUNER SECTION TUNING RANGE +88 to 10BMHz SENSITIVITY (IHF) sss. 92V) (Max. input capability: 120d8) SIGNAL TO NOISE RATIO (mono) better than 6548 CAPTURE RATIO (IHF)... less than 2048, IMAGE REJECTION better than 7548 IF REJECTION better than 9048, SPURIOUS RESPONSE REJECTION better than 8048 seueciviry better than God TOTAL HARMONIC DISTORTION Mono Tess than 0396 Sere les than 0346 sTeREO SEPARATION |... “beter than 3748 FREQUENCY RESPONSE 30 to 15000H2 "1S ANTENNA IMPEDANCE... 3000 balanced, 750 unbalanced ° TUNING RANGE os... 535 to 160K SENSITIVITY (oar antenna)» S0¢B/m IMAGE RECTION better tan Sod IPROECTION vor ..0.000 ctor than Bod seucerivine cb omnens SEMICONDUCTORS TRANSISTORS... ..189 DIODES rss. ae Pe eas ies ae ZENE DIODES POWER REQUIREMENTS Voltage 100, 117,20, 2 sft Consemption “SHOW Cote, AOOVA (mand) DIMENSIONS 594mm (2334")W, foam GA, 370mm (1434")D_ wach Mak (BO lbs) Net 25.0kg (55.0 Ibs.) Packed 7500 2. BLOCK DIAGRAM AND VALUE OF EACH LEVEL Lgeu Tne eae" *Value of each level in block diagram was measured by the followings, 1. MASTER VOLUME control Maximum 2. BASS, TREBLE, BALANCE volume control. .Center 3. Input ....PHONO-1, 2 23mV TkHz Sine Wave AUX-1, 2 98mV TkHz Sine Wave (out- | | | Conditions of Level Measuring | | | put impedance of 6000 at an audio oscillator) 4. Output rev G2W)80. Note: Each voltage value is for reference and measured by a VIVM. Insome recorders, the actual voltage value is in minor difference from the reference value. VARIO MATRIX CIRCUIT TONE CONTROL GIRCUIT— FICTER CIRCUIT. 8 =i | = epg} iE eT | ie Io raat 28 i iREUT | = Gas WETER TH Faas C QRX-7500 3. ALIGNMENTS AND ADJUSTMENTS Abbreviation Equipment [AM FM Generator Oscilloscope. -Genescope AM Standard Signal Generator ‘AM SSG FM Standard Signal Generator FM SSG FM Stereo Generator. Stereo SG Oxcilloscope Scope Audio Oscillator ‘Audio Osci Distortion Meter Dist. Meter Others Clockwise Counterclockwise Antenna ‘Modulation. 3-1. Regulated Power Supply Board Adjustment (See Fig. 3-1) Note: 1. Function. 2, Master Volume. QS Synthesizer Minimum 3, Confirm the AC Power Supply voltage sree sunece | rquirwenr [measure ovrrur | anwar | Aowsr ror] coNDION 7 | fesusied | OC voitmeier | isis Fas | waow Fea Spoty termina [ae] | VOU 3-2. Level Meter Adjustment (See Fig. 3-2) Note: 1. Function Dixrete 2 Selector AUX 5. aster Volume ini 4 Level Sat Volume “Maximum 5. For adjustment, the ui for mare then? minutes alter the power is switched on | TD SIGNAL Teasoae 7 | vevet meter | ene FRONT. REAR) Level Meter [gs | olevel | fed sigaal wo 4-cn Seibat staomy | RACY int {Seth RON Sd Rion’ | RA ont L-cy te i {one Rhy is | rear, Sige Crearety front Leh front Rch level rete lvel meter vRoa Ros wearLeh rearReh tevel meter level meter regulated ewe: ey F:1515 3-3. Driver Circuit Board Adjustment (See Figs. 3-3 and 3-4) Note 1. Master Volume Minimum 2 Make thes terminals ree tno toad. Contrm the AC Power Suply vote 3 4 After adjustment, run the unit for more than 5 minutes, then check and readjust necessary, 5. Room temperature should be 1828" (65~03°F) for bias current adjustment. T ser] sunect | equipment | measuae ourrur | apust | ADjust FoR CONDITION 7 | DCOVFront R! DC volt meter ‘Speaker terminal | f-1514 | OV £10mv_ ‘Step down meter's range Hom kech Vaan scoring | Fig 2 | OCovErontL| Sameassbove | Speakerterminat F514 | Same asabove | Same at above | | Homies"! | Gata’ | | fea | | 3 | pcovreark | same asabove | speaker terminal | Eas | Same above | sameas above mearieaer™ | Saat isd | | 4 | pcoveert | samessabove | speaker terminal | Fagy4 | simeasabove | Somes sove ie) | Fee 5 | iss curent | DC miliammeter | F-1482 casa | assim Step down meters range Front | iat va scoring | Fig 3s 6 | Bias current Same as above | F-1482 F514 Same as above Same as above Front fot Vato Fig 33 | j 7 | sisscurent | Sameas above | Fass | eas | sameasabove | Same as above Rear fos va | | Bess 8 | isecurent | sameas above | F4s2 fas | sameas above | same as above Rear | for R08 | pos Fig. F-1514 a vos ® & v0: @ z El) x a ® S © ilar reat Lich tear a Ss Lech ae BEov oeov Seay ‘lame volume volume + é fo vos ® @ all] 2 a sear Leh rear ® © Ten A trontizch Bins cavent oe current bias current \ bias current TallommeterS Fig. 34 volt meter) volt meter

You might also like