Scribd
Upload
3K views

CARPROG ST92Fxxx Programmer Manual

This document provides instructions for programming ST92F120 and ST92F150 internal EEPROMs using the CarProg programmer. It specifies using an A10 cable with six colored wires for communication, reset, clock, and power signals. It notes that the microprocessor may have a 4MHz quartz resonator and internal security that prevents writing if all bytes read as FF.

Uploaded by

jackass_t
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
3K views

CARPROG ST92Fxxx Programmer Manual

This document provides instructions for programming ST92F120 and ST92F150 internal EEPROMs using the CarProg programmer. It specifies using an A10 cable with six colored wires for communication, reset, clock, and power signals. It notes that the microprocessor may have a 4MHz quartz resonator and internal security that prevents writing if all bytes read as FF.

Uploaded by

jackass_t
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

S2.

5 CarProg ST92F120, ST92F150 internal EEPROM Programmer manual

For ST92Fxxx programming use A10 cable.

How to connect CarProg programmer: For ST92Fxxx programming use A10 cable 6 color wires: YELOW SOUT communication signal from MPU; GREEN SIN communication signal to MPU; BLUE RESET signal to MPU; ORANGE RXCLK signal to MPU, low level; BROWN VSS (ground); RED VCC switched +5V;

Notes: Quartz resonator must be 4 MHz Some times internall EEPROM have security CarProg will read all FF and write is not possible. This moment with CarProg is no way to skip security.

All right reserved www.codecard.lt

All right reserved www.codecard.lt

All right reserved www.codecard.lt

All right reserved www.codecard.lt

You might also like