Scribd
Upload
66 views

Cisco Config Reg

The document describes various configuration register settings for a router and their associated behaviors. Setting 0x102 ignores break signals and boots into the router's bootstrap at 9600 baud. Other settings determine behaviors like boot location, console baud rate, and whether the router ignores contents of non-volatile RAM. The document also lists the meaning of individual bits in the configuration register, including settings for boot location, ignoring NVRAM contents, console speed, and more.

Uploaded by

bin00010111
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
66 views

Cisco Config Reg

The document describes various configuration register settings for a router and their associated behaviors. Setting 0x102 ignores break signals and boots into the router's bootstrap at 9600 baud. Other settings determine behaviors like boot location, console baud rate, and whether the router ignores contents of non-volatile RAM. The document also lists the meaning of individual bits in the configuration register, including settings for boot location, ignoring NVRAM contents, console speed, and more.

Uploaded by

bin00010111
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Configuration Register Setting 0x102

Router Behavior

Ignores break 9600 console baud

0x1202

1200 baud rate

0x2101

Boots into bootstrap Ignores break Boots into ROM if initial boot fails 9600 console baud rate

0x2102

Ignores break Boots into ROM if initial boot fails 9600 console baud rate default value for most platforms

0x2120

Boots into ROMmon 19200 console speed

0x2122

Ignores break Boots into ROM if initial boot fails 19200 console baud rate

0x2124

NetBoot Ignores break Boots into ROM if initial boot fails 19200 console speed

0x2142

Ignores break Boots into ROM if initial boot fails 9600 console baud rate Ignores the contents of Non-Volatile RAM (NVRAM) (ignores configuration)

0x2902

Ignores break Boots into ROM if initial boot fails 4800 console baud rate

0x2922

Ignores break Boots into ROM if initial boot fails 38400 console baud rate

0x3122

Ignores break Boots into ROM if initial boot fails

57600 console baud rate

0x3902

Ignores break Boots into ROM if initial boot fails 2400 console baud rate

0x3922

Ignores break Boots into ROM if initial boot fails 115200 console baud rate

If the value you have for the configuration register is not in the table, then determine which bits are set in order to compute the value: Bit Number

Hex

Meaning


00-03 0x00000x000F

Boots Field Parameters 0x0000 Stays at the system bootstrap prompt 0x0001 Boots system image on EPROM 0x0002-0x000F Specifies a default netboot filename

06

0x0040

Ignore NVRAM contents

07

0x0080

Disable boot messages

08

0x0100

Break disabled

10

0x0400 0x0020, 0x0800, 0x1000 0x2000

IP broadcast with all zeros

5,11,12

Console line speed

13

Boots default ROM software if network boot fails

14 0x4000

IP broadcasts do not have net numbers

15

0x8000

Enables diagnostic messages Ignores NVRAM contents

You might also like