UNIVERSITY OF CAMBRIDGE INTERNATIONAL EXAMINATIONS

GCE Advanced Subsidiary Level and GCE Advanced Level

MARK SCHEME for the October/November 2010 question paper for the guidance of teachers

9709 MATHEMATICS
9709/11 Paper 1, maximum raw mark 75

This mark scheme is published as an aid to teachers and candidates, to indicate the requirements of the examination. It shows the basis on which Examiners were instructed to award marks. It does not indicate the details of the discussions that took place at an Examiners meeting before marking began, which would have considered the acceptability of alternative answers. Mark schemes must be read in conjunction with the question papers and the report on the examination.

CIE will not enter into discussions or correspondence in connection with these mark schemes.

CIE is publishing the mark schemes for the October/November 2010 question papers for most IGCSE, GCE Advanced Level and Advanced Subsidiary Level syllabuses and some Ordinary Level syllabuses.

Page 2

Mark Scheme: Teachers version GCE A/AS LEVEL October/November 2010

Syllabus 9709

Paper 11

Mark Scheme Notes Marks are of the following three types: M Method mark, awarded for a valid method applied to the problem. Method marks are not lost for numerical errors, algebraic slips or errors in units. However, it is not usually sufficient for a candidate just to indicate an intention of using some method or just to quote a formula; the formula or idea must be applied to the specific problem in hand, e.g. by substituting the relevant quantities into the formula. Correct application of a formula without the formula being quoted obviously earns the M mark and in some cases an M mark can be implied from a correct answer. Accuracy mark, awarded for a correct answer or intermediate step correctly obtained. Accuracy marks cannot be given unless the associated method mark is earned (or implied). Mark for a correct result or statement independent of method marks.

When a part of a question has two or more method steps, the M marks are generally independent unless the scheme specifically says otherwise; and similarly when there are several B marks allocated. The notation DM or DB (or dep*) is used to indicate that a particular M or B mark is dependent on an earlier M or B (asterisked) mark in the scheme. When two or more steps are run together by the candidate, the earlier marks are implied and full credit is given. The symbol implies that the A or B mark indicated is allowed for work correctly following on from previously incorrect results. Otherwise, A or B marks are given for correct work only. A and B marks are not given for fortuitously correct answers or results obtained from incorrect working. Note: B2 or A2 means that the candidate can earn 2 or 0. B2/1/0 means that the candidate can earn anything from 0 to 2.

The marks indicated in the scheme may not be subdivided. If there is genuine doubt whether a candidate has earned a mark, allow the candidate the benefit of the doubt. Unless otherwise indicated, marks once gained cannot subsequently be lost, e.g. wrong working following a correct form of answer is ignored. Wrong or missing units in an answer should not lead to the loss of a mark unless the scheme specifically indicates otherwise. For a numerical answer, allow the A or B mark if a value is obtained which is correct to 3 s.f., or which would be correct to 3 s.f. if rounded (1 d.p. in the case of an angle). As stated above, an A or B mark is not given if a correct numerical answer arises fortuitously from incorrect working. For Mechanics questions, allow A or B marks for correct answers which arise from taking g equal to 9.8 or 9.81 instead of 10.

UCLES 2010

Page 3

Mark Scheme: Teachers version GCE A/AS LEVEL October/November 2010

Syllabus 9709

Paper 11

The following abbreviations may be used in a mark scheme or used on the scripts: AEF AG BOD CAO CWO ISW MR PA SOS SR Any Equivalent Form (of answer is equally acceptable) Answer Given on the question paper (so extra checking is needed to ensure that the detailed working leading to the result is valid) Benefit of Doubt (allowed when the validity of a solution may not be absolutely clear) Correct Answer Only (emphasising that no follow through from a previous error is allowed) Correct Working Only often written by a fortuitous answer Ignore Subsequent Working Misread Premature Approximation (resulting in basically correct work that is insufficiently accurate) See Other Solution (the candidate makes a better attempt at the same question) Special Ruling (detailing the mark to be given for a specific wrong solution, or a case where some standard marking practice is to be varied in the light of a particular circumstance)

Penalties

MR 1

A penalty of MR 1 is deducted from A or B marks when the data of a question or part question are genuinely misread and the object and difficulty of the question remain unaltered. In this case all A and B marks then become follow through marks. MR is not applied when the candidate misreads his own figures this is regarded as an error in accuracy. An MR 2 penalty may be applied in particular cases if agreed at the coordination meeting. This is deducted from A or B marks in the case of premature approximation. The PA 1 penalty is usually discussed at the meeting.

PA 1

UCLES 2010

Page 4

Mark Scheme: Teachers version GCE AS/A LEVEL October/November 2010

Syllabus 9709

Paper 11

1 x + dx x
3

x 1 = + 2 x + (c ) 3 x

B1 3

co. Omission of middle term of expansion [3] can still get 2/3. co from his answer for 6ax co For 20 a3 [4]

(1 + ax)6 Term in x = 6ax Equate with 30 a = 5 Term in x3 =

B1 B1 B1 B1

6.5.4 3 a 3!

coefficient of 2500 3 f : x a 2x + 3 , g : x a x 2x , gf(x) = (2x + 3)2 2(2x + 3) = 4x2 + 8x + 3 = 4(x + 1)2 1

M1 A1 3 B1 [5]

Must be f into g, not g into f. co Allow all these as for either fg or gf.

(i)

sin x tan x sin 2 x = 1 cos x cos x(1 cos x)

M1 M1 M1 [3]

Use of tanx = sinx cosx Use of sin2x = 1 cos2x Realising the need to use difference of 2 squares. Answer given.

1 cos x cos x(1 cos x)

(ii)

1 +1+ 2 = 0 cos x cosx = x = 109.5 or 250.5

M1 A1 A1 [3] B1 B1 M1 M1 M1 A1 [6]

Uses part (i) with cos x as subject. co. for 360 1st answer. co (or CA ) co (or CB ) Must be scalar available for any pair For modulus available for any vector All linked correctly for ACB only co

AC = 6i + 10k BC = 8j +10k AC.BC = 100 AC.BC = 136164 cos ACB

UCLES 2010

Page 5

Mark Scheme: Teachers version GCE AS/A LEVEL October/November 2010

Syllabus 9709

Paper 11

(a) a + 4d = 18

B1 B1 M1 A1 [4]

co or 75 = 5/2(a + 18) a = 12 etc co Solution of sim equations co for both

5 (2a + 4d ) = 75 2
Solution a = 12, d = 1 (b) a = 16 and ar3 = r=

3 4

27 4

B1

Needs both of these

Sum to infinity = 64 7

M1 A1

[3]

Correct formula and r < 1

x a 3 2 tan( 1 x) 2 (i) Range of f 3

B1 [1] B1 [1] B2, 1, 0 Indep. [2]

co. Allow <

co

Starting at y = 3 Shape correct no turning points. Tending tangentially towards x = Attempt at making x the subject. Order of operations all ok. co but with x, not y. [3]

x (iv) y = 3 2 tan 2
1 3 x f 1 (x) = 2 tan 2

M1 M1 A1

(i)

2x + 2 y +

x = 60 2 x 4

M1 A1 [2]

Linking 60 with sum of at least 4 sides and use of radians co

y = 30 x
x 4
2

(ii) A = xy +

= x (30 x = 30x x2 (iii)

x x )+ 4 4

M1 A1 [2]

Subs y into area eqn and use co.

1 2 r 2

dA = 30 2 x dx
= 0 when x = 15 cm M1 A1 [2] M1 A1 [2]

Knowing to differentiate Sets differential to 0 + solution. co. Any valid method. co.

(iv) Max.

UCLES 2010

Page 6

Mark Scheme: Teachers version GCE AS/A LEVEL October/November 2010 M1 A1 [2] M1 A1 [2]

Syllabus 9709

Paper 11

(i)

RS = 10 6 RS = 8 cm.

Use of Pythagoras (or other) Answer given. Use of trig even if with degrees. co in radians. (Accept 0.927)

(ii) sin = 8/10 oe angle RPQ = 0.9273 radians (iii) Region = trapezium 2 sectors Area of trapezium = 40 cm 1 Large sector = 8 0.9273 2 Small sector angle = ( 0.9273) 1 Small sector = 2 2.214 2 5.90 cm2 10 y = 4x x2 + 3 (i)

B1 M1

co Use of

1 r. 2 1 r with angle = (ii) 2

M1 A1

Use of [4] co

dy = 4 2x dx
At x = 3, m = 2

B1

co

1 2 Eqn of normal y 6 = 1 ( x 3) 2 2y = x + 9
Gradient of normal = (ii) Meets axes at (0,

M1 M1 A1 [4]

Use of m1m2 = 1 Use of y k = m(x h) or y = mx + c (where m is gradient of normal) Sets x and y to 0 + midpoint formula. co. [2]

9 ) and (9, 0) 2

M1 A1

9 9 Mid-point is , 2 4

(iii) 2y = x + 9, y = 4x x2 + 3 2x2 7x + 3 = 0 oe (, 4)

M1 A1 M1 A1 [4]

Eliminates x completely. Correct eqn. Solution of quadratic. co

UCLES 2010

Page 7

Mark Scheme: Teachers version GCE AS/A LEVEL October/November 2010

Syllabus 9709

Paper 11

11

y=
(i)

9 2x dy 2 = 9(2 x) 1 dx
9 (2 x)
2

B1 B1 B1 [3]

Without the 1 Indep. With the 1. Indep. provided of form k (2x).

0. No turning points. 81

(ii) V =

(2 x)

dx
1

dx = 81(2 x)

(1)

Use of limits 0 to 1

B1 B1 M1 A1 [4] M1 M1 A1 A1 [4]

Answer without the 1 including For 1. Uses both limits in an integral of y if 0 ignored, M0. co (If omitted max 3/4)

81 (or 127) 2

(iii)

9 = x+k 2 x x2 2x + kx 2k + 9 = 0 Uses b 4ac k2 + 4k 32 end-points of 4 and 8 Range for 2 points of intersection k < 8 , k > 4.

Elimination of y Uses discriminant End-values correct. Accept , .

UCLES 2010