Scribd
Upload
644 views

PC Control DDS Software and Instructions For Use

The document provides instructions for using PC control DDS software in 4 steps: 1) Start the software by double-clicking the "PC_DDS.exe" file. 2) Select the correct port number in the upper right corner to match the port number in the Device Manager. 3) Input the required frequency number in the "Enter number areas" or click buttons to set the output frequency, which will then be displayed on the MCU LCD screen. 4) Similarly set the stepper frequency and step control. The document notes that any questions should be directed to the contact provided.

Uploaded by

olopez
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
644 views

PC Control DDS Software and Instructions For Use

The document provides instructions for using PC control DDS software in 4 steps: 1) Start the software by double-clicking the "PC_DDS.exe" file. 2) Select the correct port number in the upper right corner to match the port number in the Device Manager. 3) Input the required frequency number in the "Enter number areas" or click buttons to set the output frequency, which will then be displayed on the MCU LCD screen. 4) Similarly set the stepper frequency and step control. The document notes that any questions should be directed to the contact provided.

Uploaded by

olopez
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

PC control DDS software instructions for use V1.

0 English version

PC control DDS software instructions for use First step:start the software
Directly to double-click the catalog under "PC_DDS.exe" software, start the PC control DDS softwareas shown below:

Double-click to start the software, as shown below:

Start the software interface

The second step:select the correct port


Select the correct port number in the upper right corner Note: the port number of the selected must to be consistent with the port number of appear in the "Device Manager", As shown below:

If the port is opened successfully, the user will be prompted:

QinPinEle 4-24-2012

PC control DDS software instructions for use V1.0 English version

Port opened successfully

The third step: input frequency parameters


Users can use the mouse enter the required number in the Enter number areas, but also can click the "delete" button, clear the enter wrong number, as shown below:

Enter numbers In "Frequency controlled areas ", click on the " KHz "button of "Set the output frequency", then the output frequency is set to 20KHz, as shown below:

Set the output frequency At this point, the frequency value is also displayed in the MCU LCD screen!

The fourth step:set the stepper frequency and step control


The method of operation is similar to the above, I no longer expressed, and very grateful for your use! If you have any questions, please contact us

QinPinele 4-24-2012

QinPinEle 4-24-2012

You might also like