Scribd
Upload
609 views

Compaction Factor Test

This document summarizes the compaction factor test procedure and results. The test involves measuring the weight of partially and fully compacted concrete samples. The ratio of partially to fully compacted weight is the compaction factor, which normally ranges from 0.8 to 0.92. The test reported here found a compaction factor of 0.8362, within the normal range. The compaction factor test provides a reliable assessment of concrete workability and is particularly useful for dry mixes where the slump test is not satisfactory.

Uploaded by

abhay9911
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
609 views

Compaction Factor Test

This document summarizes the compaction factor test procedure and results. The test involves measuring the weight of partially and fully compacted concrete samples. The ratio of partially to fully compacted weight is the compaction factor, which normally ranges from 0.8 to 0.92. The test reported here found a compaction factor of 0.8362, within the normal range. The compaction factor test provides a reliable assessment of concrete workability and is particularly useful for dry mixes where the slump test is not satisfactory.

Uploaded by

abhay9911
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

1

ATOOMUS

Compaction factor test


Objective:
To calculate the compaction factor, and to know more about workability .

Introduction :
These tests were developed in the UK by Glanville ( 1947 ) and it is measure the degree of compaction For the standard amount of work and thus offer a direct and reasonably reliable assessment of the workability Of concrete . the test require measurement of the weight of the partially and fully compacted concrete and the ratio the partially compacted weight to the fully compacted weight, which is always less than one, is known as compacted factor . For the normal range of concrete the compacting factor lies between 0.8 - 0.92 .

ATOOMUS

Standard :
B.S 1881 :PART 2 1970

Apparatus :
The compaction factor apparatus shall consist of two conical hoppers mounted above a cylinder.

Trowels . One scoop about 150 mm long . A tamping rod . A balance . A compacting rod .
3 ATOOMUS

Calculation :
Wt. Of coarse aggregate : 6000 g Wt. Of (3daceih) aggregate : 6000 g Wt. Of swieleh sand : 3000 g Wt. Of cement : 3000 g Water : 3000 mL .

Wt. Of empty cylinder : 3767 g Wt. Of cylinder + partially compacted concrete : 13370 g Wt. Of partially concrete : 9603 g Wt. Of cylinder + fully compacted concrete : 15251 g Compaction factor = ( partially compacted concrete / fully compacted concrete ) = 0.8362

Result:
We get the results, and have a Compaction factor of test =

Discussion and conclusion :


For the normal range of concrete the compaction factor lies between (0.8 0.92 ) . This test is particularly useful for dryer mixes for which the slump test is not satisfactory.
4 ATOOMUS

The sensitivity of the compaction factor is reduced outside the normal range of workability and is generally unsatisfactory for compacting factor greater than 0.92 .

ATOOMUS

You might also like