Scribd
Upload
2K views

Design Calculations For Anchor Bolt

The document provides inputs and formulas for designing anchor bolts that will secure a vessel. It lists the wind load, vessel height, moment weight, total weight, bolt circle area, circumference, allowable tension, material strength, number of bolts required, and area of a single bolt. Based on these inputs, the required diameter of the anchor bolt is calculated to be 0.63 inches using formulas that calculate the maximum tension per bolt, required area of one bolt based on the total required area, and induced stress in the anchor bolts.

Uploaded by

Akshat Jain
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views

Design Calculations For Anchor Bolt

The document provides inputs and formulas for designing anchor bolts that will secure a vessel. It lists the wind load, vessel height, moment weight, total weight, bolt circle area, circumference, allowable tension, material strength, number of bolts required, and area of a single bolt. Based on these inputs, the required diameter of the anchor bolt is calculated to be 0.63 inches using formulas that calculate the maximum tension per bolt, required area of one bolt based on the total required area, and induced stress in the anchor bolts.

Uploaded by

Akshat Jain
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ANCHOR BOLT DESIGN LATER

Inputs
Bolt Area Table Bolt Size
in 0.500 0.625 0.750 0.875 1.000 1.125 1.250 1.375 1.500 1.625 1.750 1.875 2.000 2.250 2.500 2.750 3.000

Wind Load (From PVElite) Height of Vessel with Skirt Moment Weight of Vessel Bolt Circle Area within Bolt Circle Circumference of Bolt Circle Maximum Tension Allow. Stress Value of Bolt Mat. No. of Anchor Bolts Req.Area of one Bolt Dia of Bolt from Table against Root Area Induced Stress in Anchor Bolts Corrosion Allowance for Bolt Formulas Used i Maximum Tension ( lb/in ) ii Req. Area of One Bolt ( Sq.in ) iii Stress in Anchor Bolt ( psi ) Resuslt: Required Diameter of Anchor Bolt Required Diameter of Anchor Bolt

P H M W AB CB T SB N BA d Sind CA

lbs 18.00 ft 54,000.00 lbs-ft 90388.00 lbs 84.00 in 2 5,538.96 in 264 in -225.70 lb/in 15,000.00 psi
3000.00 8.00

in2 0.126 0.202 0.302 0.419 0.551 0.693 0.89 1.054 1.294

-0.50

in

1.515 1.744 2.049 2.3 3.02 3.715 4.618

0.63 in -24,267.36 psi 0.13

in

T = 12
BA =
SB =

M W AB CB

5.621

TC B SB N
TC B BA N

0.00 0.00

in mm

You might also like