WL005 - WL10: Silicon Bridge Rectifiers WOB
Uploaded by
tarpinoWL005 - WL10: Silicon Bridge Rectifiers WOB
Uploaded by
tarpinoWL005 - WL10
PRV : 50 - 1000 Volts Io : 1.0 Ampere
SILICON BRIDGE RECTIFIERS WOB
0.39 (10.0) 0.31 (7.87) 0.22 (5.59) 0.18 (4.57)
FEATURES :
* * * * * * High case dielectric strength High surge current capability High reliability Low reverse current Low forward voltage drop Ideal for printed circuit board
1.10 (27.9) MIN.
AC
1.00 (25.4) MIN.
0.034 (0.86) 0.028 (0.71)
AC
AC
MECHANICAL DATA :
* Case : Reliable low cost construction utilizing molded plastic technique * Epoxy : UL94V-O rate flame retardant * Terminals : Plated leads solderable per MIL-STD-202, Method 208 guaranteed * Polarity : Polarity symbols marked on case * Mounting position : Any * Weight : 1.29 grams
Rating at 25 C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%.
0.22 (5.59) 0.18 (4.57)
0.22 (5.59) 0.18 (4.57)
Dimension in inches and (millimeter)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
RATING
Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Current 0.375" (9.5 mm) lead length Tc = 50C Peak Forward Surge Current Single half sine wave Superimposed on rated load (JEDEC Method) Rating for fusing ( t < 8.3 ms. ) Maximum Forward Voltage per Diode at I F = 1.0 Amp. Maximum DC Reverse Current Ta = 25 C at Rated DC Blocking Voltage Ta = 100 C Typical Junction Capacitance per Diode (Note 1) Typical Thermal Resistance (Note 2) Operating Junction Temperature Range Storage Temperature Range
SYMBOL WL005 WL01 WL02 WL04 WL06
VRRM VRMS VDC IF(AV) IFSM I 2t VF IR IR(H) CJ RJA TJ TSTG 50 35 50 100 70 100 200 140 200 400 280 400 1.0 30 10 1.2 10 1.0 24 36 - 50 to + 150 - 50 to + 150 600 420 600
WL08 800 560 800
WL10 1000 700 1000
UNIT
Volts Volts Volts Amps. Amps. A2 S Volts A mA pf C/W C C
Notes :
1 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts. 2 ) Thermal resistance from Junction to Ambient at 0.375" (9.5 mm) lead length P.C. Board mounting.
UPDATE : APRIL 23,1998
RATING AND CHARACTERISTIC CURVES ( WL005 - WL10 )
FIG.1 - DERATING CURVE FOR OUTPUT RECTIFIED CURRENT
1.0 30
PC Board
FIG.2 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT
AVERAGE FORWARD OUTPUT CURRENT, AMPERES
0.8
PEAK FORWARD SURGE CURRENT, AMPERES
0.375
24
T J = 55 C
0.6
Copper Pads 0.22" x 0.22" (5.5 x5.5mm)
18
0.4
12 SINGLE HALF SINE WAVE (JEDEC METHOD)
0.2 60 Hz, Resistive or Inductive load. 0 0 25 50 75 100 125 150 175
10
20
40
60
100
CASE TEMPERATURE, ( C)
NUMBER OF CYCLES AT 60Hz
FIG.3 - TYPICAL FORWARD CHARACTERISTICS REVERSE CURRENT, MICROAMPERES
20 10
FIG.4 - TYPICAL REVERSE CHARACTERISTICS
FORWARD CURRENT, AMPERES
10
T J = 100 C
1 TJ = 25 C 0.1 Pulse Width = 300 s 1 % Duty Cycle
1.0
0.1
T J = 25 C
0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8
0.01 0 20 40 60 80 100 120 140
FORWARD VOLTAGE, VOLTS
PERCENT OF RATED REVERSE VOLTAGE, (%)
This datasheet has been download from: www.datasheetcatalog.com Datasheets for electronics components.
