Scribd
Upload
2K views

Solidworks Exercise 1

The document provides instructions for modeling a simple stool in Solidworks. It describes 5 steps: 1) extruding a 50x50mm square 10mm to create the top, 2) extruding 10x10mm squares in each corner 50mm to create the legs, 3) sketching and extruding circles on the inner faces of the legs to create parallel supports, 4) repeating for the remaining supports, and 5) applying a 5mm fillet to inside edges where the legs meet the top.

Uploaded by

Waqar Dar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views

Solidworks Exercise 1

The document provides instructions for modeling a simple stool in Solidworks. It describes 5 steps: 1) extruding a 50x50mm square 10mm to create the top, 2) extruding 10x10mm squares in each corner 50mm to create the legs, 3) sketching and extruding circles on the inner faces of the legs to create parallel supports, 4) repeating for the remaining supports, and 5) applying a 5mm fillet to inside edges where the legs meet the top.

Uploaded by

Waqar Dar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Solidworks Tutorials

Exercise 1: Stool
Now that you have completed Tutorial 1 you should have the knowledge required to tackle the following exercise: Below is a drawing of a simple stool. Your task is to model the stool in Solidworks.

Solidworks Tutorials

Exercise 1: Stool
Now that you have completed Tutorial 1 you should have the knowledge required to tackle the following exercise: Below is a drawing of a simple stool. Your task is to model the stool in Solidworks.

Fillet Edges Apply a Fillet to the inner-underside edges to create these rounds

Extrude the Top Create the top section by extruding a square 10mm

Extrude Supports Create circle sketches on the side of the legs then extrude to create the supports.

Extrude Legs Create the legs by extruding squares from the top surface

Solidworks Tutorials

Exercise 1: Stool
. is a drawing of a simple stool. Your task is to Below model the stool in Solidworks using the following steps as a guide. 1. First create a New Part and start a sketch on the Top workplane. Draw a 50 x 50 mm square and Extrude 10mm 2. On the bottom face of your newly created shape draw a 10 x 10 mm square in each corner and Extrude 50mm 3. Start a sketch on one of the inner faces of the legs and draw two circles corresponding to two of the parallel supports, then Extrude 30mm 4. Repeat step 3 for the remaining two supports 5. Apply a Fillet of 5mm to the inside edges where the legs meet the top.

1.

2.

3.

4.

5.

You might also like