Scribd
Upload
67 views

Part Modeling Assignment 6: Lofted Solids

The document describes using lofting to model various 3D objects from 2D cross sections along a path. It provides instructions for lofting a tetrahedron from an equilateral triangular base. It then gives an exercise to loft a transition solid with three different cross sections - a pentagonal base, hexagonal middle section, and circular top section. Hints are provided on using the "Sketch on Path" command to create the cross sections along an axis to prepare for lofting.

Uploaded by

kannanviknesh
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
67 views

Part Modeling Assignment 6: Lofted Solids

The document describes using lofting to model various 3D objects from 2D cross sections along a path. It provides instructions for lofting a tetrahedron from an equilateral triangular base. It then gives an exercise to loft a transition solid with three different cross sections - a pentagonal base, hexagonal middle section, and circular top section. Hints are provided on using the "Sketch on Path" command to create the cross sections along an axis to prepare for lofting.

Uploaded by

kannanviknesh
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

PART MODELING ASSIGNMENT 6: Lofted Solids

Objective: The aim of this assignment is to understand the lofting technique and use it to create some objects. Creating these objects by any other method would take longer and involve more effort. Therefore lofting comes handy for modeling some non-prismatic solids. We begin our study by creating a tetrahedron first.

PART I Tetrahedron

Figure 1: Lofted Tetrahedron Procedure: 1. Draw an equilateral triangle using the polygon command on the workplane. Let the circumcentre of the triangle be at the origin and the side length be 50mm. 2. Calculate the vertical height of the 4th point where the other three edges of the tetrahedron will be connected and create a 3D point taking z equal to the calculated height. 3. Loft Command: Next we make use of the loft command to create a solid from the triangular base to the vertical point we created in the last step. 4. To verify the newly created edge length: Measure the length of any one of the newly created edges to check your calculations are right.

Figure 2: The I-DEAS loft command

Figure 3: The lofted tetrahedron

Exercise 6a: Transition solid having three different cross sections


The following solid has to be modelled using lofting method. We have a pentagonal base to begin with. The diameter of the circumcirlce of the base is 30mm. The second hexagonal section is at 30mm from the base on the z-axis. The diameter of the circumcircle of this hexagon is 50mm. At the top we have a circular section at 30mm from the previous section with diameter 70mm.

Figure 4: Lofting with multiple sections Hint: We need to create the three sections along a path; it could be a coordinate axis also. We may need the following command to create these sections. Sketch on Path Command:
Use this command to designate a path on which a reference plane is created. You can then sketch wireframe on this plane. There are several methods (available as MB3 options) for controlling the orientation of the reference plane: Normal to Path keeps the Z axis tangent to your path, and the X axis is determined by a rule that minimizes spin about the Z axis. Normal to Plane keeps the Y axis parallel to the fixed direction. The software projects the fixed direction onto the section plane. Normal to vector keeps the Z axis parallel to the selected parallel plane. Revolve about Axis keeps the hinge line always on the section plane, and the section plane revolves about the hinge line. The Y axis is always parallel to the hinge line.

You might also like