Scribd
Upload
2K views

Homework #8 Solution Manual Thermodynamics Moran and Shapiro

This document contains the solutions to three homework questions about thermodynamics. Question 1 involves calculating the mass and temperature change of air in a copper tank when it is connected to a high pressure air supply. Question 2 involves calculating the heat transfer in a two-stage heating process of water in a rigid tank. Question 3 involves calculating the final mass and quality of water, and velocity of vapor, in a piston-cylinder system as vapor escapes through a hole in the piston.

Uploaded by

ryan_martin_53
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views

Homework #8 Solution Manual Thermodynamics Moran and Shapiro

This document contains the solutions to three homework questions about thermodynamics. Question 1 involves calculating the mass and temperature change of air in a copper tank when it is connected to a high pressure air supply. Question 2 involves calculating the heat transfer in a two-stage heating process of water in a rigid tank. Question 3 involves calculating the final mass and quality of water, and velocity of vapor, in a piston-cylinder system as vapor escapes through a hole in the piston.

Uploaded by

ryan_martin_53
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 10

ENES 232: Thermodynamics

SOLUTIONS: Homework #8
Assigned: 3/11/13 Due: 3/25/13
Question #1 Transient A rigid copper tank, initially containing 1 m3 of air at 295K, 5 bar, is connected by a valve to a large supply line carrying air at 295K, 15 bar. The valve is opened only as long as required to fill the tank with air to a pressure of 15 bar, at which point the air in the tank is at 310K. The copper tank, which has a mass of 20 kg, is at the same temperature as the air in the tank, both initially and finally. The specific heat of the copper is c = 0.385 kJ/kg-K. Assuming ideal gas behavior for the air, determine (a) the initial and final mass of air within the tank, each in kg, and (b) the heat transfer to the surroundings from the tank and its contents, in kJ, ignoring kinetic and potential energy effects. (630)

Question #2 Transient Analysis A rigid tank having a volume of 0.1 m3 initially contains water as a two-phase liquid-vapor mixture at 1 bar and a quality of 1%. The water is heated in two stages: Stage 1: Constant-volume heating until the pressure is 20 bar. Stage 2: Continued heating while saturated water vapor is slowly withdrawn from the tank at a constant pressure of 20 bar. Heating ceases when all of the water remaining in the tank is saturated vapor at 20 bar. For the water, evaluate the heat transfer, in kJ, for each stage of heating. Ignore KE and PE effects. (4204, 8725)

Question #3 Transient Analysis A vertical piston-cylinder arrangement contains 1 lbm of saturated water at a temperature of 300F and a quality of x = 0.5. A small hole in the piston allows saturated vapor to escape, resulting in the piston dropping slowly over time. The piston drops until it comes to rest on the remaining saturated liquid. Assuming a well-insulated system: a) b) c) What is the final mass of water in the system? How much of the original liquid remains? If the saturated vapor undergoes an adiabatic expansion to atmospheric pressure and 250F as it leaves the hole in the piston, what is its velocity?

(0.5, 100, 756) Solution:

Simplified solution (acceptable)

You might also like