Scribd
Upload
67 views

Power Electronics Question Paper Part4

This document appears to be an exam for a power electronics course, consisting of 5 questions covering various topics related to power electronics and motor drives. The questions address half bridge and full bridge inverters, AC-DC converters, cycloconverters, induction motor control methods like scalar control and volts/hertz control, active filters, HVDC transmission, and flexible AC transmission systems (FACTS) devices. The exam instructions specify that students should attempt all questions and make assumptions where necessary, with point values listed to the right of each sub-question.

Uploaded by

vagoliyo
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
67 views

Power Electronics Question Paper Part4

This document appears to be an exam for a power electronics course, consisting of 5 questions covering various topics related to power electronics and motor drives. The questions address half bridge and full bridge inverters, AC-DC converters, cycloconverters, induction motor control methods like scalar control and volts/hertz control, active filters, HVDC transmission, and flexible AC transmission systems (FACTS) devices. The exam instructions specify that students should attempt all questions and make assumptions where necessary, with point values listed to the right of each sub-question.

Uploaded by

vagoliyo
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Seat No.

: _____

Enrolment No.______ BE- VIth SEMESTEREXAMINATION MAY- 2012

GUJARAT TECHNOLOGICAL UNIVERSITY


Subject code: 160902 Subject Name: Power Electronics-II Time: 10:30 am 01:00 pm Date: 11/05/2012 Total Marks: 70

Instructions:
1. Attempt all questions. 2. Make suitable assumptions wherever necessary. 3. Figures to the right indicate full marks.

Q.1

(a) Explain Mc Murray Bedford half bridge inverter with circuit diagram and 07 waveforms. (b) Explain Single phase transformer connection changers in detail. 07 (a) Compare AC & DC drives. 07 (b) Explain static Kramer drive and static Scherbius drive for slip power recovery 07 scheme for large size induction motor control. OR (b) A 400V, 4 pole, 50Hz, 3 phase, star connected induction motor has the following 07 parameters: No. of stator turns/phase is twice the number of rotor turns/phase, r1=0.64 , x1=1.1 , r2=0.8 , x2=0.12 . The load torque is proportional to square of speed and is 40 N-m at 1440 rpm. If the motor speed is 1300 rpm, find (a) load torque (b) rotor current (c) stator applied voltage. Neglect no load current. (a) In a single phase to single phase cycloconverter, the input voltage is 120V (rms),60 Hz. The load resistance is 5 and the load inductance is L=40 mH. The frequency of the output voltage is 20Hz. If the converters are operated as semi converters such that 0 and the delay angle is p =2/3, determine (a) the rms value of output voltage Vo, (b) the rms current of each thyristor IR, and (c) the input PF. (b) For a single phase full wave AC controller, the input rms voltage is Vs=120V, 60Hz. The load is L=6.5 mH and R=2.5.The delay angles of thyristors are equal i.e. 1= 2=/2. Determine (a) the conduction angle of the thyristor, which conducts for positive half cycle (b) the rms output voltage Vo (c) the rms thyristor current IR (d) the rms output current Io (e) the average current of a thyristor IA and (f) the input PF. OR (a) Explain Third harmonic PWM in detail with output waveforms. (b) Explain Space Vector switching and Space Vector sequence used for Space Vector Modulation (SVM) (a) Explain AC voltage controllers with PWM control (b) Discuss Matrix converter in detail
OR

Q.2

Q.3

07

07

Q.3

07 07

Q.4

07 07 07 07 07 07 07 07

Q.4

Q.5

Q.5

(a) Explain scalar control with reference to Closed-Loop control of induction motor (b) Discuss volts/hertz control and self controlled synchronous motor drives with basic schematic arrangements. (a) Discuss Active filters (b) Write a brief note on HVDC OR (a) Classify the FACTs device and explain any one device in detail with application. (b) Explain RF heating
******* 1

You might also like