Scribd
Upload
1K views2 pages

724K John Deere Mantenimiento

UPTIME MAINTENANCE PLANNER 724K As Required Inspect tires and check pressure check wheel bolt torque check engine air cleaner elements Inspect air conditioning compressor and alternator belt clean cooler cores check windshield washer fluid level check coolant level in surge tank check and clean or replace air cleaner dust unloader valve check engine oil level check transmission oil level Add coolant extender as indicated by COOL-GARD (tm) II test strips check rear camera and radar object detection system (if equipped) Every 10 hours or Daily

Uploaded by

Erwin Castro
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views2 pages

724K John Deere Mantenimiento

UPTIME MAINTENANCE PLANNER 724K As Required Inspect tires and check pressure check wheel bolt torque check engine air cleaner elements Inspect air conditioning compressor and alternator belt clean cooler cores check windshield washer fluid level check coolant level in surge tank check and clean or replace air cleaner dust unloader valve check engine oil level check transmission oil level Add coolant extender as indicated by COOL-GARD (tm) II test strips check rear camera and radar object detection system (if equipped) Every 10 hours or Daily

Uploaded by

Erwin Castro
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

UPTIME MAINTENANCE PLANNER

724K
As Required
Inspect tires and check pressure Check wheel bolt torque Inspect engine air cleaner elements Inspect air conditioning compressor and alternator belt Clean cooler cores Check windshield washer fluid level Drain water from primary fuel filter and clean stainer Drain water from auxiliary fuel filter/water separator (if equipped) Check coolant level in surge tank Check and clean or replace air cleaner dust unloader valve Check engine oil level Grease loader linkage and cylinder pivots (unless NeverGrease equipped) Replace final fuel filter Replace fast fill fuel breather filter (if equipped) Check and clean or replace cab fresh air filter Check and clean or replace cab recirculating air filter Check transmission oil level Add coolant extender as indicated by COOL-GARD II test strips Check rear camera and radar object detection system (if equipped)

Every 10 Hours or Daily


Check hydraulic oil level Inspect external seal (excludes Powerllel)

Every 100 Hours Initial Service - 250 Hours***


Drain and refill engine oil and replace filter ***Perform initial service once after the first 250 hours of operation Take engine oil sample Drain and refill front and rear axle oil

Every 250 Hours Every 500 Hours


Grease upper and lower driveline sliding joints and lower U-joints Check air intake and charge air cooler hoses Drain and refill engine oil and replace filter Replace in-line fuel strainer Replace primary fuel filter Replace final fuel filter Replace fast fill fuel breather filter (if equipped) Check front and rear axle oil level Grease front and rear shaft seals on park brake Clean engine crankcase vent tube Replace air cleaner dust unloader valve Replace engine air cleaner elements Check coolant Drain and refill front and rear axle oil 2 Clean front and rear axle oil recirculation screens (if equipped)
1

Clean and tighten battery terminals and check electrolyte level Replace auxiliary fuel filter/water separator (if equipped) Replace hydraulic reservoir breather filter Check park brake oil level Take hydraulic oil sample Take axle oil sample Take engine coolant sample Take transmission oil sample Take diesel fuel sample

Every 1000 Hours


Grease frame hinge pivots Drain and refill park brake oil Clean hydraulic pump case drain screen

Every 2000 Hours


Grease front and rear axle shaft seals Rerun clutch calibration (advanced display unit) Adjust engine valve lash

Drain and refill transmission oil and replace filter 1 Reduce service intervals to 1500 hours in severe applications, which run the torque converter at high loads for more than approximately 25% of the time. (For example: basement digging, land clearing, etc.)

The magnetic drain plug is serving its purpose when a ball of fine metal particles or chips are found on the magnet. If concerned with the amount of debris on the plug, clean and check again after running a short time with fresh oil.

Every 4000 Hours


Drain and refill hydraulic system oil Clean hydraulic system fill strainer Inspect driveline dampener Replace hydraulic system return filter Replace crankshaft dampener

Every 5000 Hours Every 6000 Hours


Drain and refill cooling system

T231736 13JULY09 T232196-28 | T232197-63 | T253281-59

UPTIME MAINTENANCE PLANNER

REQUIRED PARTS Description


Engine Oil Filter Primary and Final Fuel Filter Kit Auxiliary Water Separator Fuel Filter (if equipped) In-Line Fuel Strainer Fast Fill Fuel Breather Filter (if equipped) Hydraulic Reservoir Breather Filter Primary Air Cleaner Element Secondary Air Cleaner Element Air Cleaner Dust Unloader Valve Engine Rocker Arm Cover Gasket Transmission Oil Filter Cab Fresh Air Filter Cab Recirculation Filter Hydraulic System Return Filter Crankshaft Dampener John Deere PLUS-50 Engine Oil John Deere PLUS-50 Hydraulic Oil HY-GARD Oil COOL-GARD II Pre-Mix Part Number RE521420 RE525523 AT365869 AT223493 T225008 AM39653 AT223226 AT175224 T158495 R527884 AT336140 AT191102 AT307501 AT335977 RE520465 TY6389* TY25852* TY6354* TY26575 44 L (11.6 gal) 0.6 L (20 oz) 67.1 L (17.7 gal) Initial Service 250 Hours 1 Every 250 Hours Every 500 Every 1000 Every 2000 Every 4000 Every 6000 Hours Hours Hours Hours Hours 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1

As Required As Required 1 1 28 L (7.4 gal) 110 L (29.1 gal) 67.1 L (17.7 gal)

28 L (7.4 gal)

28 L (7.4 gal)

28 L (7.4 gal)

28 L (7.4 gal)

28 L (7.4 gal)

67.1 L (17.7 gal) 33.8 L (9 gal)

As Required TY26603 Coolant Extender Fluid Analysis Kits** AT317904 1 1 1 1 1 Diesel Engine Oil AT303189 1 1 1 1 Transmission Oil AT303189 2 2 2 2 Axle Oil AT303189 1 1 1 1 Hydraulic Oil AT180344 1 1 1 1 DieselScan Kit AT183016 1 1 1 1 COOLSCAN PLUS Kit TY26605 1 1 1 COOL-GARD II Test Strips *See operator's manual for recommended oil type and oil viscosities based on operating temperatures. **Based on fluid analysis results, intervals may need to be adjusted for your operating conditions. Consult your local John Deere Dealer.

1 1 2 1 1 1 1

T231736 13JULY09 T232196-28 | T232197-63 | T253281-59

You might also like