Scribd
Upload
65 views

ECG Sample Experiment

This is a sample experiment proposal that talks about how to make an ecg using the application of amplifiers

Uploaded by

Hanna Abejo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
65 views

ECG Sample Experiment

This is a sample experiment proposal that talks about how to make an ecg using the application of amplifiers

Uploaded by

Hanna Abejo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

PAMANTASAN NG LUNGSOD NG MAYNILA

UNIVERSITY OF THE CITY OF MANILA



Intramuros, Manila



COLLEGE OF ENGINEERING AND TECHNOLOGY

DEPARTMENT OF COMPUTER ENGINEERING



ELECTRONIC CIRCUITS ANALYSIS AND DESIGN


DESIGN PROJECT PROPOSAL


ECG (ELECTROCARDIOGRAM) AMPLIFIER








Abejo, Hanna E.

Balili, Ervin L.

Correa, Gia Patricia R.

Dela Cruz, Maika Danica G.




Engr. Evangeline Lubao

Instructor

DESCRIPTION OF THE PROJECT

The Electrocardiograph (ECG) signal is an electrical signal generated by the
hearts beating, which can be used as a diagnostic tool for examining some of the
functions of the heart. It has a principal measurement range of 0.5 to 4 mV and
signal frequency range of 0.01 to 250 Hz.

There are many factors that should be taken into consideration in the design of an
ECG amplifier, such as the frequency distortion, saturation distortion, interference
from electric devices and other sources. The most important kind of noise in an
ECG amplifier is the 60 Hz noises, since using a band-pass filter can easily reject
both the DC and high frequency noise. A major source of noise when one is
recording or monitoring the ECG is the electric power system, (a). Electromagnetic interference
from nearby high power radio or television can
also be picked up by a close loop of lead wires.


To eliminate the noises mentioned above, we can use differential amplifiers. Since
most noises are common mode voltage, the differential amplifier can eliminate
them. This three-op-amp amplifier circuit is frequently called an instrumentation
amplifier. It has high input impedance, a high CMRR, and a gain a gain that can
be changed by adjusting R1. This circuit finds wide use in measuring biopotential,
because it rejects the large 60 Hz common-mode voltages that exist on the body.
In many modern electrocardiographic systems, people are using a driven-right-leg
system. The patient is not grounded at all. Instead, the right leg electrode is
connected to the output of an auxiliary op amp. The common-mode voltage on the body is
sensed by the two averaging resistors Ra,


inverted, amplified and fed back to the right leg. Such a negative feed back drives
the common-mode voltage to a low level. It can also provide some electric safety,
because the auxiliary op amp will saturate when an abnormally high voltage
appears between the patient and ground.


Resources:
ECE 525 #1 Design by XiYao Zhang (Background of the Study)

You might also like