Scribd
Upload
64 views

Safety Alert: From The International Association of Drilling Contractors

A safety alert from the International Association of Drilling Contractors describes an incident where an employee was struck in the mouth by a hammer while helping secure bolts. The employees lacked situational awareness and the injured employee was in the line of fire. The company is looking for engineering solutions to prevent future line of fire incidents and emphasizing situation awareness through oversight and culture changes.

Uploaded by

Wilman Ardila Barbosa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
64 views

Safety Alert: From The International Association of Drilling Contractors

A safety alert from the International Association of Drilling Contractors describes an incident where an employee was struck in the mouth by a hammer while helping secure bolts. The employees lacked situational awareness and the injured employee was in the line of fire. The company is looking for engineering solutions to prevent future line of fire incidents and emphasizing situation awareness through oversight and culture changes.

Uploaded by

Wilman Ardila Barbosa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Safety Alert

From the International Association of Drilling Contractors


ALERT 15-07

POOR SITUATION AWARENESS/LINE OF FIRE INCIDENT RESULTS IN OSHA RECORDABLE


WHAT HAPPENED:
Two crew members on their first day back were hammering up bolts on nipple up. During the pre-job meeting the two
men had anticipated getting hit with the hammer while holding the hammer wrench. As a defense they tied a 3 long
piece of rope around the hammer wrench so that one employee could hold a bind on it while the other man swung the
hammer. As the two men worked their way around the stack the man holding the rope ended up in the line of fire as he
pulled the rope. On one of the swings the hammer glanced off of the top of the hammer wrench. Before the employee
could stop the forward momentum of the hammer, it made contact with the man holding the rope striking him in the
mouth. This strike resulted in an injury that met the requirements of an OSHA Recordable.
WHAT CAUSED IT:
-Lack of situational awareness
-IP in direct line of fire
CORRECTIVE ACTIONS: To address this incident, this company did the following:
Culture/Process: Although having a good pre-job meeting and several Error-Likely Situations were anticipated and
defenses were put in place this incident still occurred, we didnt maintain good situation awareness while working our way
around the stack. Employees should always be using situation awareness and have a questioning attitude. By doing so
one or both of the men should have noticed that the short rope coupled with the angle that the man was pulling it placed
him directly in the line of fire.
Oversight: Key leaders should be checking in on employees work progress and watching to make sure all defenses are
in place and adequate. Recently one of our Operators conducted a stand down on one of our rigs to help raise
awareness of incidents caused by standing in the line of fire. We greatly appreciate the support of this Operator who was
very open about the increase in incidents they have seen due to standing in the line of fire.
Engineering: Management is currently looking for a practical engineering defense that we can use to hold hammer
wrenches and other tools correctly while keeping other employees out of the line of fire.
This is a re-enactment and not a picture from the actual incident or rig! This picture is strictly a visual aid to
show the line of fire one may find himself in during nipple up.

The Corrective Actions stated in this alert are one companys attempts to address the incident, and do not
necessarily reflect the position of IADC or the IADC HSE Committee.
This material is presented for information purposes only. Managers & Supervisors should evaluate this information to determine if it can
be applied to their own situations and practices
Copyright 2015 International Association of Drilling Contractors All rights reserved.
Issued July 2015

You might also like