Lecture 14: Intelligent Sensor Systems: Compensation Computation Communications Integration
Lecture 14: Intelligent Sensor Systems: Compensation Computation Communications Integration
g Compensation
n Self-diagnostics, self-calibration, adaptation
g Computation
n Signal conditioning, data reduction, detection of trigger events
g Communications
n Network protocol standardization
g Integration
n Coupling of sensing and computation at the chip level
n Micro electro-mechanical systems (MEMS)
g Others
n Multi-modal, multi-dimensional, multi-layer
n Active, autonomous sensing
Compensation
g Self-diagnostics versus self-calibration
g Compensation
n Offset compensation
g To fully utilize the dynamic range of ADCs
n Gain
g By means of programmable gain amplifiers
n Linearity
g By means of look-up tables
n Cross-sensitivity
g Temperature control and/or compensation
g Discussion
n How could you incorporate some of these elements into our e-nose?
Intelligent Sensor Systems
Ricardo Gutierrez-Osuna
Wright State University
Computation
g Various degrees of computation
n
n
n
n
n
MIDDLE LAYER
Info. Processing
LOWER LAYER
Sensor Sensor Sensor Sensor
Multi-sensor systems
Intelligent Sensor Systems
Ricardo Gutierrez-Osuna
Wright State University
Audio
Video
Others
Processing approaches
g Classical
g Connectionist
g Fuzzy logic
n Fuzzy control
n Fuzzy signal processing
g Evolutionary
n Genetic algorithms
n Genetic programming
g Hybrid approaches
n Neuro-fuzzy
n Neuro-genetic
n
Communications
g Traditionally, each sensor system is custom-designed for
specific applications by experience designers
g This approach has several limitations
n Complexity: a limited number of sensors may be installed in each
system, imposed by the level of complexity that human designers can
deal with
n Cost: system is composed of a small number of highly specialized,
relatively expensive sensors
n Flexibility: the resulting system cannot be easily expanded, modified,
maintained or repaired. Highly trained personnel is required for these
functions
g Solution
n Standardization of transducer interfaces
g Electrical, mechanical(?), communications protocol
Integration
g On-chip signal conditioning and self-diagnostics constitute
smartness in the ADXL series of accelerometer ICs from Analog
Devices
Integration
DATA ACQUISITION
COMPUTING
Embedded
Micro-controllers
Digital Signal Processors
4,8,16,32-bits
Monitoring devices
Volatile memories
Static RAM
Dynamic RAM
Non-volatile memories
ROM
EEPROM
Flash
Disk-on-a-chip
Instrumentation amplifiers
Filters
Sample and Hold
Analog to Digital Converters
Voltage to Frequency Converters
Multiplexers
Oscillators
Voltage references
Sensor-specific devices
Complete DAQ sub-systems
COMMUNICATIONS
Line drivers
Line receivers
Bus transceivers
Bus controllers
POWER SUPPLY
AC/DC converters
DC/DC converters
Intelligent Sensor Systems
Ricardo Gutierrez-Osuna
Wright State University
CONTROL
Examples
g Microchip temperature to voltage converters (TC1047)
n Sensor provides an output voltage directly proportional to measured
temperature
g Temperature range: -40C to +125C
g Linear temperature slope: 10mV/ C
g Small 3-pin SOT-23B Package
Examples
g Microchip dual-trip temperature
sensor (TC623)
n Integrated temperature sensor and
logic threshold
n 8-pin DIP or SOIC for direct PCB
mounting
n 2 user-programmable temperature
set-points (w/ external resistor)
n 2 independent temperature limit
outputs
g Application
n Low temp reduces CPU CLK
n High temp further reduces CPU CLK
n Control output starts fan
10
Examples
g Microchip 2-wire serial temperature sensor
n Standard 2-wire serial interface
g Programmable trip point and hystheresis
g Digital readout
g Device configuration
n Address lines
g Up to 8 devices can share
the 2-wire bus lines
11
Example
g Dallas Semiconductor 1-Wire digital thermometer (DS18B20)
n
n
n
n
12
Example
g Analog Devices 2-axis accelerometer (ADXL202)
n Can measure both dynamic acceleration (e.g., vibration) and static
acceleration (e.g., gravity)
n The outputs are Duty Cycle Modulated (DCM) signals
g Duty cycles (ratio of pulsewidth to period) proportional to the acceleration in
each of the 2 sensitive axe
g These outputs may be measured directly with a microprocessor counter,
requiring no A/D converter or glue logic.
13
14
Example
g Analog Devices 2-axis self-test accelerometer (ADXL250 )
n Low noise (80dB SNR), wide dynamic range (50g), reduced power
consumption
n A Logic 1 applied to the self-test input will cause an electrostatic force
to be applied to the sensor that will cause it to deflect!
15