Power Generation Using Simple Household Taps Short
Power Generation Using Simple Household Taps Short
Temporary design
WORKING
1. The water from the overhead tank will come through the pipes and will have a considerable amount of
pressure energy. This will be connected to the device and will pass through the dirt collector which will have
a fine filter to separate the impurities.
2. This water will then be passed through the nozzle where it will attain some velocity and the strike the blades
of the wheel the penstock provided will control the amount of water striking the blades.
3. The water will strike the blades and will make it rotate and the shaft of the motor will also rotate thus
producing electricity which can be stored and used later.
4. This water will then flow out following the guide which is attached to the casing.
IMPROVEMENTS
2 sets of wheels, nozzles and motors can be used to increase the power generation and also the mass flow
rate of water.
A bypass valve can be provided so that the water flow can be directly achieved.
Small devices can also be made which can directly be attached to the tap and there will not be a nozzle in it.
Gears can be used to vary the speed-torque of the input to the motor.
APPLICATIONS
Households.
Agricultural Pumps.
Rainwater Drainage.
Commercial Industries were water is used on a large scale.
We will be learning the design of turbine wheels, nozzles, CFD analysis and many more concepts..
WHY WE DISCARDED THIS IDEA
We discarded this idea because it was done by our seniors of batch 2013-2014
REFERENCES
www.youtube.com/10w mini turbine generator from ebay
http://control.com/Generating electricity using household water pressure
http://www.lowtechmagazine.com/2013/09/power-from-the-tap-water-motors.html
https://grabcad.com/library/pelton-turbine-9