NTS02G Network Time Server v2
NTS02G Network Time Server v2
DATASHEET
3-port NTP
& PTP Time
Server
NTS 02-G
The NTS 02-G is a high precision, 3 port GNSS
(GPS/ GLONASS) referenced NTP, SNTP and
PTP (IEEE1588v2) Grandmaster or Boundary
clock that provides secure, accurate and reliable
time synchronization to enterprise networks.
Each of the ports are independently addressable
and logically isolated allowing multiple Networks
to be connected to the same clock without
compromising the network security. The
addition of multi-level password protection and
user access rights, SNMPv3, and built-in NTP
amplification attack immunity, makes the
NTS 02-G a versatile synchronization solution
for a range of critical network applications.
SUPPORTS
- DC IRIG-B (Un-modulated, DCLS)
- C37.118.1, AFNOR NF S87-500 Extensions
- User defined pulses (including 1 PPS)
- DCF77 Simulation
- PTP (Supports Power Profile - C37.238, and
Telecom Slave Profile ITU G. 8265.1)
- NTP/ SNTP
- SNMP v1, v2c & v3
- PTP (IEEE 1588v2)
KEY FEATURES
- References GPS & GLONASS networks
- Isolated power supply
- 3 independent RJ45 Ethernet ports
- NTP/SNTP
- PTP (IEEE 1588v2) Master/Slave function
- UTC and LST with user defined DST
- Remote configuration over Ethernet
- Remote firmware upgrades
- Configuration encryption and security
- Enhanced security and encryption that exceeds
NERC CIP requirements
www.tekron.com
PHYSICAL
- Dimensions: 160 mm x 155 mm x 40 mm (W x D x H)
- Weight: 0.8 kg
- 1U 19 rack mount bracket accessory included
- IP40 (Ingress Protection rating)
FRONT PANEL
- 2-line x 16 character FSTN LCD display
- 2 LEDs indicating multiple statuses, including:
- Sync Status
- Antenna cable fault
- Satellite acquisition mode
- Display mode button
- USB configuration port (Type B)
SNMP
- v1, v2c & v3 support can be independently enabled
- Configurable v1, v2c community names &
security groups
- Fully configurable via SNMP
- v3 User-based Security Module (USM) support
- USM authentication methods: MD5, SHA
- USM privacy methods: DES, AES
- USM MIB support
GNSS RECEIVER
- L1, C/A code, 32 Channel Parallel-tracking receiver
Frequency:
1598 MHz
Sensitivity:
Acquisition
-155 dBm
Tracking
-160 dBm
General
- DHCP auto-configuration with fallback to ARP
tested link-local address
- VLAN packet tagging
- Auto-MDIX
- Auto-negotiate
NTP
- Stratum-1 NTP & SNTP time server
- Multicast & Broadcast server capability
- Optional MD5 authentication
Notifications
- SNMP trap generation v1, v2c & v3
- SNMPv3 traps can be authenticated & privatised
via USM
- Syslog (RFC-3164 & 5424 varieties)
Plus:
- 1 x IRIG-B input
Signals:
- DC IRIG-B (Un-modulated, DCLS)- Extensions C37.118.1
Characteristics: RS422
- 7 V to +12 V (common mode range)
1/8 unit load (150 k )
Built in 120 for optional termination
ESD protection
IEC 61000-4-2
OSCILLATOR - TCXO
Protocols Supported:
Plus:
- 1 x Configurable output
- DC IRIG-B (Un-modulated, DCLS)- Extensions C37.118.1,
AFNOR NF S87-500
- User defined pulses (1 to 1000 PPS)
- DCF77 simulation
- Timing accuracy <100 ns of UTC
Characteristics:
RS422
Can drive upto 50 unit loads
Open circuit: 3.3 V
Loaded: 1V @ 80 mA
ESD protection
IEC 61000-4-2
Plus:
- 2 x Configurable Relay Outputs, NO contacts.
Relay outputs:
2 x Normally Open,
Solid State Relays
ESD protection ITU K.20/21
Contact rating: 275 VDC, 100 mA
Contact protection:
275 VDC, 0.5A (fused)
www.tekron.com
CONFIGURATION SOFTWARE
Windows-based configuration software is available
for download on www.tekron.com.
Remote configuration over Ethernet includes the
following user adjustable features:
- Multi-level access control
- Privacy & authentication methods equivalent to
SNMP USM
- Supervisor-mode prevents non-approved changes
- Test mode
- Commissioning tool
Mounted
on a 19 1U
bracket
OPTIONAL ACCESSORIES
Physical
- GNSS antenna
- Antenna cable
- Adjustable antenna mount
- Lightning protection kit
Power supply:
L = 14 - 36 VDC (3 pin)
M = 20 - 75 VDC (3 pin)
H= 85 - 265 VAC/ 90-300 VDC
(3 pin)
Power Rating:
4W max (copper)
Operating Temperature: -10C to +65C
Humidity:
10 to 95% RH
(non condensing)
Back
View
www.tekron.com
ABOUT TEKRON
CONTACT US
Website:
www.tekron.com
Phone:
+64 4 566 7722
Australia Freephone:
1800 608 572
North America Freephone:
1800 256 2309
Sales Enquiries:
[email protected]
Support Enquiries:
[email protected]
TEK-NTS02G-DS-v2-072016
2016 Tekron International Ltd. All rights reserved. Tekron and Tekron Logo are trademarks of Tekron International Ltd. Specifications are subject to change without notice.