Digital Modulation Techniques
Digital Modulation Techniques
data in RF frequency
phase S (t ) cos{ ct (t )}
0 1/T 2/T 3/T
Frequency
1
Non-Coherent Detection Coherent detection
Envelope Detection of ASK Coherent Detection of ASK
Th
Bandpass Lowpass
Decision
Filter Filter
cos t
Bandpass Lowpass
Rectifier Decision Threshold Voltage
filter Filter Carrier
Recovery
Circuit
Threshold Voltage
PSK
FSK
Binary PSK modulation waveform
Binary FSK modulation waveform
PSK(coherent) FSK(coherent)
1
ASK Pe erfc ( E / 4 N 0 )1/ 2 PSK achieves small bit error rate (BER) for the same C/N
2 10−4
1 (carrier-noise ratio)
PSK
FSK(noncoherent)
Pe erfc (E / N 0 )1/ 2 PSK(differential)
2
1 E 1/ 2 10−5
PSK has constant envelope (no information in amplitude ),
FSK Pe
2
erfc (
2N0
)
and is robust to time-varying fading channel.
10−6
erfc : complementary error function PSK is popularly used in many communication systems
E : energy per bit
10−7
6 8 10 12 14 16 18 such as satellite and mobile communication systems.
SNR (Signal-to-noise ratio in dB)
N0 : power spectrum density (psd) of noise
BER Performance
2
Multilevel Amplitude Shift Keying(M-ASK) Multi-ary Phase Shift Keying (MPSK)
MASK refers to ASK that transmit
In MPSK, signal amplitude is constant. Each signal
more bits by using multilevel constellation point is placed on the circumference where
amplitude a(t) of baseband the center equals to origin.
waveform. MASK is usually called
as Multilevel ASK, or MASK, Q
Q Q
where k =log 2 M bits of
information are transmitted by
I I I
using M-level amplitude. Waveform of MASK signal
In MASK, band, 1/k of occupancy bandwidth can be conserved 4-ary PSK 8-ary PSK
while transmitting k bit information. That is, by using multilevel 16-ary PSK
amplitude, the bit rate can be increased without the bandwidth Phase allocation of MPSK signal
expansion. Larger transmission power is required.
±1
×
±1 cosωt
Serial/Parallel +
Input data
×
±1
sinωt
QPSK modulator
Iwao Sasase, Keio University Iwao Sasase, Keio University
page15 page16
Quadrature Detection
QPSK Demodulation
In quadrature detection, for symbol detection, plus and minus
(Quadrature Detection) of in-phase and quadrate components can be decided independently.
Quadrate( Q ) Quadrate( Q )
× LPF In-phase component (1,1)
(−1,1)
Decision
Signal phase 0° 90° 180° 270°
cosωt boundary
BPF LPF input 1 0 −1 0
In-phase( I ) In-phase( I )
× LPF Quadrate component
Signal phase 0° 90° 180° 270°
(1,−1)
sinωt LPF input 0 1 0 −1 (−1, − 1)
QPSK Quadrature detection of
QPSK receiver cos component
3
π/4 shift QPSK Quadrature Amplitude Modulation (QAM )
QAM changes both amplitude and phase.
adopted in mobile phone(PDC) Quadrature multilevel ASK using two orthogonal carriers
(sin and cos )of the same frequency
2bits/symbol
8 signal points are allocated 2 Emin 2 Emin
on the circumference sQAM (t ) ai cos( 2 f ct ) bi sin( 2 f ct )
Q Ts Ts
In each symbol transmission, QPSK 0 t T i 1, 2,....., M
signal points are shifted by π/4.
Since there are no phase transition I 16QAM
crossing origin, the signal envelope
does not become zero, and thus, 4bits/symbol
envelope fluctuation is smaller
Compared to QPSK, frequency
compared to the conventional QPSK.
efficiency is improved to be
double. 16QAM signal points
Gaussian
Filter
Normalized frequency fT
Power spectral of GMSK and MSK
4
Error rates characteristic of
GMSK and MSK
Rate