Scribd
Upload
315 views2 pages

Replacing The Hood Maxfire

This document provides instructions for replacing the MaxFire Hood on a stove. It lists the necessary tools which include a drill, rivet tool, screwdriver, and socket. The steps are to remove the control panel and side panels, drill out existing rivets on the stove frame and back panel, remove the old hood, install the new hood using replacement rivets, and reinstall the control panel and side panels. Diagrams are provided to identify rivet locations.

Uploaded by

Al Malley
Copyright
© Public Domain
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
315 views2 pages

Replacing The Hood Maxfire

This document provides instructions for replacing the MaxFire Hood on a stove. It lists the necessary tools which include a drill, rivet tool, screwdriver, and socket. The steps are to remove the control panel and side panels, drill out existing rivets on the stove frame and back panel, remove the old hood, install the new hood using replacement rivets, and reinstall the control panel and side panels. Diagrams are provided to identify rivet locations.

Uploaded by

Al Malley
Copyright
© Public Domain
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Replacing the MaxFire Hood

Tools needed to replace the hood

• Drill with 1/8” drill bit


• Rivet tool
• Flat head screw driver
• 5/8” socket or nut driver

Replacing the hood

• Remove the screws on the back panel holding the control panel in place. See
Figure 1.
• Remove the control panel by sliding it forward (towards the front of the
stove). This will be tight and a rubber mallet might be needed.
• Mark and disconnect the ribbon cable from the panel and set the panel to the side.
• Remove the side panels by removing the screw at the top.
• Remove the wrap from the front of the stove (two screws on each side,
inside the side panels). See Figure 1.
• Drill out the rivets holding the hood to the stove frame.
ƒ Three rivets near the back of the stove frame (under side profile). See
Figure 1.
ƒ Three rivets on the back panel. See Figure 1
ƒ Three rivets inside the hopper. See Figures 3 & 4.
ƒ One rivet under the hood (if applicable). See Figure 2.
• Remove the hood.
• Install new hood. If needed remove the louvers from the old hood and attach them to
the new hood.
• Using the rivets included in the kit, install the hood.
• Install the control panel, connecting the ribbon cable to the panel first. Be sure to
connect the ribbon cable in the same orientation as it can off.
• Install the screws on the back of the stove to anchor the control panel.

DWG. NO. 4000270 Rev B 10/2007 Kit: 4000171, 4000204


4000189, 4000212
4000197, 4000551
Control panel screws

Kit: 4000171, 4000204


4000189, 4000212
4000197, 4000551
Wrap screws – Remove 5 rivets
right side
Figure 1 Figure 3
Remove these 3
rivets

10/2007
DWG. NO. 4000270 Rev B
Remove rivet
under hood
Figure 2 Figure 4

You might also like