0% found this document useful (0 votes)
59 views

Fall 2014 Computer Communication Networks HW#4 (Due Date: 2014/10/20 Hand in On E3 System)

This document outlines four questions for a computer communication networks homework assignment. Question 1 involves calculating bit rate, SNRdB, and bandwidth for a digitized signal. Question 2 asks to calculate bit rates for different modulation schemes. Question 3 requires calculating frame size, rate, duration, and efficiency for a TDM system combining 20 digital sources. Question 4 involves drawing a configuration diagram and calculating crosspoints, connections, and blocking factor for a three-stage space-division switch.

Uploaded by

Tài Lâm
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
59 views

Fall 2014 Computer Communication Networks HW#4 (Due Date: 2014/10/20 Hand in On E3 System)

This document outlines four questions for a computer communication networks homework assignment. Question 1 involves calculating bit rate, SNRdB, and bandwidth for a digitized signal. Question 2 asks to calculate bit rates for different modulation schemes. Question 3 requires calculating frame size, rate, duration, and efficiency for a TDM system combining 20 digital sources. Question 4 involves drawing a configuration diagram and calculating crosspoints, connections, and blocking factor for a three-stage space-division switch.

Uploaded by

Tài Lâm
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Fall 2014 Computer Communication Networks

HW#4 (Due date: 2014/10/20 hand in on E3 system)


Question 1:
We have sampled a low-pass signal with a bandwidth of 200 KHz using
1024 levels of quantization.
a. Calculate the bit rate of the digitized signal.
b. Calculate the SNRdB for this signal.
c. Calculate the PCM bandwidth of this signal.
Question 2:
Calculate the bit rate for the given baud rate and type of modulation.
a. 1000 baud, FSK
b. 1000 baud, ASK
c. 1000 baud, BPSK
d. 1000 baud, 16-QAM
Question 3:
We need to use synchronous TDM and combine 20 digital sources, each
of 100 Kbps. Each output slot carries 1 bit from each digital source, but
one extra bit is added to each frame for synchronization. Answer the
following questions:
a. What is the size of an output frame in bits?
b. What is the output frame rate?
c. What is the duration of an output frame?
d. What is the output data rate?
e. What is the efficiency of system (ratio of useful bits to the total bits).

Continued on the next page

Question 4:
We need a three-stage space-division switch with N=100. We use 10
crossbars at the first and third stages, and 4 crossbars at the middle
stage.
a. Draw the configuration diagram.
b. Calculate the total number crosspoints.
c. Find the possible number of simultaneous connections.
d. Find the possible number of simultaneous connections if we use one
single crossbar(100 100).
e. Find the blocking factor, the ratio of the number of connections in c
and in d.
Please answer the questions in your own words.

You might also like