Scribd
Upload
316 views

Fall Protection Checklist

This checklist summarizes OSHA regulations for fall protection from 29 CFR 1926.501 to 1926.503. It addresses requirements for fall protection relating to walking-working surfaces, holes, hoist areas, unprotected sides/edges, wall openings, falling objects, training programs, and certification of training. Requirements include use of guardrails, covers, fall arrest systems, barricades, hard hats, and retraining as needed to protect workers from fall hazards.

Uploaded by

Kevin Yudhistira Pribadi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
316 views

Fall Protection Checklist

This checklist summarizes OSHA regulations for fall protection from 29 CFR 1926.501 to 1926.503. It addresses requirements for fall protection relating to walking-working surfaces, holes, hoist areas, unprotected sides/edges, wall openings, falling objects, training programs, and certification of training. Requirements include use of guardrails, covers, fall arrest systems, barricades, hard hats, and retraining as needed to protect workers from fall hazards.

Uploaded by

Kevin Yudhistira Pribadi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Fall Protection Checklist

This checklist covers regulations issued by the U.S. Department of Labor, Occupational Safety and Health Administration
(OSHA) under the construction standards 29 CFR 1926.501 to 1926.503.

Wall Openings

Equipment

Holes

Hoist Areas

Unprotected Sides and


Edges

General

Question

Regulation

Answer

Do walking and working surfaces have the strength and


[29 CFR 1926.501(a)(2)]
structural integrity to support people safely?
Are employees prohibited from working on walking and working [29 CFR 1926.501(a)(2)]
surfaces that cannot support them safely?
If fall protection systems are required, are they installed before
Note: This requirement
employees begin work?
is not found in .502(a)(2)
Do guardrail systems, safety net systems, or personal fall arrest
[29 CFR 1926.501(b)(1)]
systems protect employees when they work on unprotected
sides and edges of walking and working surfaces that are 6 feet
or more above a lower level?
Do guardrail systems, safety net systems, or personal fall arrest
[29 CFR
systems protect employees during construction of leading edges 1926.501(b)(2)(i)]
6 feet or more above lower levels?
Note: Exceptions are permitted if these systems are infeasible or create a greater hazard. However, a fall protection plan
must still be developed and implemented.
Do guardrail systems or personal fall arrest systems protect
[29 CFR 1926.501(b)(3)]
workers in a hoist area from falling 6 ft. or more to lower levels?
Does a personal fall arrest system protect employees if guardrail [29 CFR 1926.501(b)(3)]
systems are removed for hoisting operations, requiring
employees to lean through the access opening or out over the
edge of the access opening (e.g., to receive or guide equipment
and materials)?
Do personal fall arrest systems, covers, or guardrail systems
[29 CFR
erected around holes protect employees on walking and working 1926.501(b)(4)(i)]
surfaces more than 6 feet above lower levels from falling
through holes (including skylights)?
Do covers protect employees on a walking and working surface
[29 CFR
from tripping in or stepping into holes (including skylights)?
1926.501(b)(4)(ii)]
Do covers protect employees on a walking and working surface
[29 CFR
from objects falling through holes (including skylights)?
1926.501(b)(4)(iii)]
Do guardrail systems or equipment guards protect employees
[29 CFR
from falling from less than 6 feet onto dangerous equipment?
1926.501(b)(8)(i)]
Do guardrail systems, personal fall arrest systems, or safety net
[29 CFR
systems protect employees 6 feet or more above dangerous
1926.501(b)(8)(ii)]
equipment from fall hazards?
Are employees protected from falling by a guardrail system, a
[29 CFR
safety net system, or a personal fall arrest system if they are
1926.501(b)(14)]
working on, at, above, or near wall openings (including those
with chutes attached) where (a) the outside bottom edge of the
wall opening is 6 feet or more above lower levels, and (b) the
inside bottom edge of the wall opening is less than 39 inches
above the walking and working surface?

Protection From Falling Objects

When an employee is exposed to falling objects, are they


required to wear a hard hat?

[29 CFR 1926.501(c)]

When an employee is exposed to falling objects, is one of the


following measures implemented?
Erect toe boards, screens, or guardrail systems to prevent
objects from falling from higher levels.
Erect a canopy structure and keep potential fall objects far
enough away from the edge of the higher level so that those
objects would not go over the edge if they were displaced.
Barricade the area to which objects could fall, prohibit
employees and students from entering the barricaded area, and
keep objects that may fall far enough away from the edge of a
higher level so that those objects would not go over the edge if
they were displaced.
Has a training program been provided to everyone who might be
exposed to fall hazards?

[29 CFR 1926.501(c)]

[29 CFR 1926.503(a)(1)]

Note: The training program must enable each employee to recognize the hazards of falling and know the procedures for
minimizing these hazards.
Is the training program conducted by a competent person?
[29 CFR 1926.503(a)(2)]

Training

The term "Competent Person" is used in many OSHA standards and documents. An OSHA "competent person" is defined as "one who is
capable of identifying existing and predictable hazards in the surroundings or working conditions which are unsanitary, hazardous, or
dangerous to employees, and who has authorization to take prompt corrective measures to eliminate them" [29 CFR 1926.32(f)]. By way
of training and/or experience, a competent person is knowledgeable of applicable standards, is capable of identifying workplace hazards
relating to the specific operation, and has the authority to correct them.

Have individual certification records been prepared that contain


the name or other identity of the person trained, the date(s) of
the training, and the signature of the employer or person who
conducted the training?
Is the latest training certification for all persons trained available
for inspection?
Is retraining conducted if a person can no longer recognize the
hazards of falling or follow the proper procedures?
Is retraining conducted when changes in the workplace render
previous training obsolete?
Is retraining conducted when changes in the types of fall
protection systems or equipment render previous training
obsolete?
Is retraining conducted if a person cannot use fall protection
systems or equipment or has not retained the requisite
understanding or skill?

Added Notes:

[29 CFR 1926.503(b)(1)]

[29 CFR 1926.503(b)(2)]


[29 CFR 1926.503(c)]
[29 CFR 1926.503(c)(1)]
[29 CFR 1926.503(c)(2)]

[29 CFR 1926.503(c)(3)]

You might also like