Experiment 1 - ChE Lab
Experiment 1 - ChE Lab
CHE150-1L/B41
Student, School of Chemical Engineering and Chemistry, Mapa Institute of Technology, Manila, Philippines
ABSTRACT
This experiment studies fluid flow regimes by analyzing the flow pattern of the dye in water. The fluid flow regimes are
laminar, transition, and turbulent flow. Reynolds Number Apparatus is used for this analysis through observing the dye with
water that flows out of the discharged valve. Before doing so, the dye in the smaller internal pipe must be distinct, straight,
and smooth. The observed flow pattern of the dye in water can be proven right by means of Reynolds Number. This
Reynolds Number was able to get by the parameters which are the inside diameter of the pipe and velocity, density,
viscosity of water. The inside diameter of the pipe is constant 0.2093 m while the density and viscosity is dependent on
temperature of water. Volume of the water per ten seconds and the cross sectional area of the pipe which is 0.0003441 m^2
are needed to compute for the velocity. The values of Reynolds number corresponded to the type of flow observed.
Keywords: Flow Pattern, Reynolds number, Fluid Flow Regimes
1.
Introduction
Vd
(1)
2. Methodology
Materials and Equipment
The primary equipment used to meet the objectives in
this experiment is the Reynolds Number Apparatus (see
Figure 2.1). This apparatus consists of a dye vessel, head
tank, inside pipe, gate valve, water inlet, and two outlets.
Aside from Reynolds Number apparatus, dye, thermometer,
stopwatch and beaker were also utilized in gathering the
required data.
Experimentation
Figure 2.1 Reynolds Number Apparatus
1 of 4
1
2
3
4
5
2x10-5
4.5x10-5
6.5x10-5
1x10-4
6.25x10-5
Nre
1
2
3
4
5
1634.15
3678.94
5313.08
8173.54
5107.76
993.402
Flow
Pattern
Smooth
Unstable
Unstable
Unstable
Unstable
Laminar
Transition
Turbulent
Turbulent
Turbulent
V=
kg
3
m
Where
Viscosity = 0.7392 cP
Type of flow
Trials
1-4 Flow Pattern and their corresponding type of flow
have
an
increasing velocity calculated using the formula:
Temperature = 34 C
Density =
0.0581
0.1308
0.1889
0.2906
0.1816
V
A (2)
3.441 x 104 m2
V, m^3/s
u, m/s
2 of 4
N =
inertia forces
viscous forces
(3)
4.
Conclusion
References
Balachandran, P. (2011). Engineering Fluid Mechanics.
New Delhi: PHI Learning Private Limited.
Wang, D. L. (n.d.). MEEG331 Incompressible Fluids
Laboratory . Retrieved April 29, 2016, from University of
Delaware
College
of
Engineering
:
http://research.me.udel.edu/~lywang/meeg331/labs/reynold
s.pdf
3 of 4