Transport Transports

Canada Canada

VFR CIRCUIT PROCEDURES AT

UNCONTROLLED AERODROMES
Communications Requirements MF/ATF Communication Procedures (see TCAIM4.5.7)
Note: If your aircraft is radio-equipped, it is recommended
Information can be exchanged with a flight service station (FSS), community
aerodrome radio station (CARS), universal communications (UNICOM),
Overhead View that the same calls be made at non-MF aerodromes.
Arrival: (CAR602.101)
or vehicle operators by directed transmissions, or with other aircraft
by broadcast transmissions. See the Transport Canada Aeronautical Report position, altitude, arrival procedure
Information Manual(TCAIM) RAC4.5 for the current requirements. intentions and estimated time of landing (ETL)
at least 5min prior to entering the area.
It is essential that pilots be aware of other traffic and exchange information Maintain a listening watch on the designated frequency.
when approaching or departing an uncontrolled aerodrome, since
CROSSWIND Report when joining the circuit,
some aircraft may be receiver only (RONLY) or no radio (NORDO).
LEG giving position in the pattern.
DEPARTURES
Report when on the downwind leg, if applicable.
Report when established on final.
DOWNWIND Report when clear of the active runway after landing.
Standard Left-Hand Pattern LEG Operations on manoeuvring area: (CAR602.99)
Report intentions and maintain listening watch
Before arriving at an uncontrolled aerodrome,
prior to entering the manoeuvring area.
plan your approach to the circuit.
Departure: (CAR602.100)
If it is necessary to cross over the aerodrome prior to joining
the circuit, or after departure, it is recommended that the Report intentions before moving onto take-off surface.
crossover be made at least 500ft above the circuit altitude. Ascertain by radio and by visual observation
that no conflict is likely during takeoff.
UPWIND
Report departure from aerodrome traffic circuit.
SIDE
Monitor the designated frequency until
well clear of the MF/ATF area.
Circuits: (CAR602.102)
BASE LEG FINAL
Report when entering the downwind leg.
Where designated, a mandatory frequency(MF) Report, with intentions, when established on final.
or aerodrome traffic frequency (ATF) area is Report when clear of the active
normally a circle with a 5-NM radius, capped runway after the final landing.
at 3000ft above aerodrome elevation(AAE).
All radio-equipped aircraft must monitor
a common designated frequency.
At aerodromes that have published instrument
approaches, the MF area may be expanded DEPARTURES
to include the approach area. See the Canada Climb to circuit altitude
Flight Supplement (CFS) for current information. before making any turrns.

Join here only if

no conflict exists.

Transiting Aircraft
Overflying Aerodromes (See TC AIM RAC 5.5)
Transiting aircraft shall not operate at a height of
less than 2000ft above an aerodrome.
[Canadian Aviation Regulation (CAR) 602.96(4)]

Make all descents to the circuit on

the upwind side, then cross the
aerodrome at midfield, at 1000ft AAE
or at the published circuit altitude.

CAUTION
At non-MF aerodromes, or when MF If the aerodrome is equipped
procedures are not invoked, keep a with an instrument approach,
sharp lookout. NORDO traffic may IFRarrivals may also be landing via
At aerodromes where MF also be established in, or be entering, straightin or circling procedures.
procedures are in effect, aircraft the circuit without other traffic or
may also join the circuit from the the ground station being aware.
flight paths indicated in blue.

See CAR 602 Division V,TC AIM (TP 14371) and the CFS for the latest information.

TP 11541 TC-1002940
(06/2010)

VFR_2010_TP11541.indd 1 100630 2:44 PM