Scribd
Upload
122 views

Chapter 11 - Group II

This chapter discusses Group II elements and their compounds. It describes their physical properties, reactions with oxygen, water and acids. It also discusses the properties and reactions of Group II oxides, hydroxides and carbonates. Thermal decomposition of Group II salts, nitrates and carbonates is covered. Uses of magnesium oxide and calcium compounds are also mentioned.

Uploaded by

Nabindra Ruwali
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
122 views

Chapter 11 - Group II

This chapter discusses Group II elements and their compounds. It describes their physical properties, reactions with oxygen, water and acids. It also discusses the properties and reactions of Group II oxides, hydroxides and carbonates. Thermal decomposition of Group II salts, nitrates and carbonates is covered. Uses of magnesium oxide and calcium compounds are also mentioned.

Uploaded by

Nabindra Ruwali
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

CHAPTER 11: Group II

11.1 Physical Properties of Group II Elements


11.2 Reactions of Group II Elements
11.3 Group II Oxides, Hydroxides and Carbonates
11.4 Thermal Decomposition
11.5 Uses of Group II Compounds

Learning outcomes:

(a) describe the reactions of the elements with oxygen, water and dilute acids.
(b) describe the behaviour of the oxides, hydroxides and carbonates with water and with dilute
acids.
(c) describe the thermal decomposition of the nitrates and carbonates.
(d) interpret, and make predictions from, the trends in physical and chemical properties of the
elements and their compounds.
(e) explain the use of magnesium oxide as a refractory lining material
(f) describe and explain the use of lime in agriculture.
11.1 Physical Properties of Group II Elements
Introduction to Group II elements

1) Group II elements(also called the 'alkaline earth metals') are s-block elements
with a characteristic outer shell configuration ns.

2) Group II elements are very reactive metals. They have low electronegativity and
are readily oxidised, they always exhibit an oxidation state of +2 in their
compounds. This is because the two outer s electrons are readily lost during a
reaction to achieve a noble gas configuration.
M M + 2e ; where M = A Group II element

Variation in atomic radius

1) The atomic radius increases going down the Group.


This is because going down the Group, each
succeeding element has one more shell of
electrons. The distance between nucleus and outer
electrons are progressively further.

Variation in first ionisation energy

1) The first ionisation energy decreases down the


Group. This is because the distance between nucleus
and outer electrons increases, and the outer electrons
are more shielded.

2) These two factors outweigh the increasing nuclear charge. So, the attractive
force between nucleus and outer electrons decreases and less energy is
required to remove the electron.
Variation in electronegativity

1) Electronegativity decreases down the Group. This is


because the distance between the nucleus and the
bonded pair of electrons increases down the Group.
Therefore the electrons are held less strongly by the
nucleus.

2) In other words, the reducing power(and reactivity) increases down the Group.

11.2 Reactions of Group II Elements


Reaction with oxygen gas, O2

1) All Group II elements(except beryllium) burn in oxygen with a bright flame to


form monoxides.
2M(s) + O2(g) 2MO(s) ; where M = A Group II element

2) i. 2Mg(s) + O2(g) 2MgO(s) ; burns with brilliant white flame


ii. 2Ca(s) + O2(g) 2CaO(s) ; burns with brick red flame
iii. 2Sr(s) + O2(g) 2SrO(s) ; burns with crimson red flame
iv. 2Ba(s) + O2(g) 2BaO(s) ; burns with apple green flame

Magnesium burning Calcium burning Strontium burning Barium burning


Reaction with water, H2O

1) All Group II elements(except beryllium) reacts with water to form hydroxides


and hydrogen gas.
M(s) + 2H2O(l) M(OH)2(aq) + H2(g) ; where M = A Group II element

2) i. Beryllium has no reaction with cold water or steam even at red heat due to
the formation of protective oxide layer on its surface.
ii. Magnesium reacts very slowly with cold water, taking several days to collect
a test tube of hydrogen gas and a weakly alkaline magnesium hydroxide
solution.
Mg(s) + 2H2O(l) Mg(OH)2(aq) + H2(g) ; very slow, pH = 9
However, it reacts rapidly with steam to produce magnesium oxide and
hydrogen gas. This is because the hydroxide formed thermally decompose
into an oxide.
Mg(s) + H2O(g) MgO(s) + H2(g) ; very fast

iii. Calcium, strontium and barium reacts vigorously with cold water to give
hydroxides.
Ca(s) + 2H2O(l) Ca(OH)2(s) + H2(g)
Sr(s) + 2H2O(l) Sr(OH)2(aq) + H2(g)
Ba(s) + 2H2O(l) Ba(OH)2(aq) + H2(g)
Note:
i. Ca(OH)2 appears as white precipitate. It is sparingly soluble therefore a
weakly alkaline solution will also be formed.

3) The reactivity of the elements with water increases down the Group. In other
words, they become more soluble going down the Group.

Reaction with acids

1) All Group II elements react with acid to give hydrogen gas and the
corresponding salt.
M(s) + H(aq) M(aq or s) + H2(g) ; where M = A Group II element

2) i. Beryllium reacts slowly with acids and has no reaction at room temperature.
ii. The rest of Group II metals react with increasing vigorous going down the
Group.
11.3 Group II Oxides, Hydroxides and Carbonates
Group II oxides

1) All Group II oxides(except beryllium oxide) reacts with water, at least to some
extent to give the corresponding hydroxides.

2) i. Beryllium oxide is insoluble because Be ion is a very small and highly


charged ion, thus making the lattice energy of BeO exceptionally high.
ii. Magnesium oxide is only slightly soluble in water, producing a weakly alkaline
solution.
iii. Addition of calcium oxide with water is a very vigorous and exothermic
reaction.

3) All Group II oxides(except beryllium oxide) are basic. They react with acids to
give the corresponding salt and water.

4) Beryllium oxide, on the other hand, is amphoteric. It reacts with both acid and
base.

Group II hydroxides

1) Group II hydroxides are not very soluble, and they do not react with water.
However, the solubility increases down the Group.

2) i. Magnesium hydroxide is only slightly soluble in water, with a pH of about 9.


ii. Calcium hydroxide(slaked lime) is moderately soluble to give a solution called
"lime water".
3) Group II hydroxides behave as a base and react with acids to give the
corresponding salt and water.

Group II carbonates

1) Group II carbonates are mainly insoluble, and they do not react with water. The
solubility decreases down the Group.

2) Group II carbonates react with acid to form salt, carbon dioxide and water.
MCO3(s) + H M(aq or s) + CO2(g) + H2O(l) ; where M = A Group II
element

11.4 Thermal Decomposition


Thermal decomposition of Group II salts

1) In general, compounds with high charge density cation and large anion
size tend to decompose more easily(less stable on heat) due to the greater
polarisation of anion by the cation.

2) Thermal decomposition of Group II salts decreases down the Group. In other


words, the thermal stability of Group II salts increases down the Group.

3) This is because going down the Group, the cation size increases while the anion
size remains unchanged. Therefore the charge density and polarising power of
cation decreases and the anion cloud is less polarised. The compound is more
stable on heating.

4) Group II salts are less stable compared to Group I salts due to the higher
charge density of M ion.

Thermal decomposition of Group II nitrates

1) All Group II nitrates decompose on heating to give the corresponding metal


oxide, brown nitrogen monoxide gas and oxygen gas.
2M(NO3)2(s) 2MO(s) + 4NO2(g) + O2(g) ; where M = A Group II element
2) Thermal stability of Group II nitrates increases down the Group. This is
because the cation size increases down the Group, this reduces the charge
density and polarising power of cation. The nitrate ion is less polarised and the
compound is more stable.

Thermal decomposition of Group II carbonates

1) All Group II carbonates decompose on heating to give the corresponding metal


oxide and carbon dioxide gas.
MCO3(s) MO(s) + CO2(g) ; where M = A Group II element

2) Thermal stability of Group II carbonates increases down the Group. This is


because the cation size increases down the Group, this reduces the charge
density and polarising power of cation. The carbonate ion is less polarised and
the compound is more stable.

11.5 Uses of Group II Compounds


1) Some ceramics contain magnesium oxide, MgO and they can be used as:
i. electrical insulators in industrial electrical cables.
ii. a refractory in furnace linings because it has a high melting point.(However, it
cannot be used in furnaces where acid is present due to its basic nature)
iii. in fire-resistant wall boards.

2) Calcium compounds have many uses, this includes:


i. calcium carbonate(limestone) to make cement.
- It is roasted in a lime kiln so that it decomposes into calcium oxide, CaO
(quicklime). The cement made is mixed with rocks to make concrete.
ii. using calcium hydroxide/oxide/carbonate to treat acidic soil as they react
with acids.

You might also like